Installing New Speakers in a 1994 Ford Ranger
ฝัง
- เผยแพร่เมื่อ 3 พ.ค. 2014
- Pretty easy especially with the specific connectors.
Disclaimer:
Due to factors beyond the control of Hank's Garage, I cannot guarantee against improper use or unauthorized modifications of this information. Hank's Garage assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Hank's Garage recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of Hank's Garage, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Hank's Garage. - ยานยนต์และพาหนะ
![เจ้าผู้เดียว - ดิด คิตตี้ [OFFICIAL MV]](http://i.ytimg.com/vi/q0NLCYKBOTo/mqdefault.jpg)
LMAO "these are made by pyle, but i'm hoping they're not piles of SHIT" hahahaha classic man.. thanks for the vid though.. very helpful!
No pun intended xD lol
March 2019. I just replaced all four speakers in my 94 Ford Ranger with these ''Pyle''s, I soldered wires onto the speakers then butt spliced the speakers in the truck wiring (also installed a Kenwood KMM-BT222U) Sounds alot better than the old speakers n stereo, doesn't boom as I go down the street I ain't no gangsta wannabe. Now my truck sounds like a concert hall inside it! These Pyles are good speakers but you have to have a good stereo to push them! Do some research before purchasing any speakers, make sure your stereo puts out enough power to run the speakers but not so much that you blow them in a week! Usually stock speakers in an older Ranger are only rated for 25 watts each. Don't waste your time n money just mixin and matchin!
That pun was totally intended! lol
Called the bed a catch all lmao
I know it's been a long time, but did you use the same speakers in both the front and the back? Also I wondered if you kept the radio you had.
I just installed Kicker 6x8 s in the front doors of a 99 ranger. The specs on the speakers will work good with factory radio for now, and will handle some additional power later on. I was pissed no speaker wire behind rear grills. oh well for now
Excellent video, but I was hoping for more of a demo at the end. I have a '93 Ranger, which is essentially the same as yours. There isn't anything faulty with my speakers, but as you know they sound pretty lousy. Did you find that installing these new speakers was a significant improvement and do you think they are worth it even if the stock speakers still perform as intended?
I love my music, but I don't love it in my beloved Ranger.
+Ted Riggs ya due to copyright I cant really demo them, but yet they are alot better than the stock ones.
Quick connect wires? You're missing out on dripping molten solder(soldering gun $30) on your carpet and burning your fingers with a heat gun($60) shrinking the shrinking wrap. $ 10 you fool! LOL
Lol that and I do that shit enough at work man these make it so much easier
Work smarter not harder
@@hanksgarage_ were those quick connects just called quick connects or Is there more information on what there called
How did the Pyle speakers sound? I want to get new speakers but looking for something cheap!
You know what they sound pretty good and are still working perfectly. Id buy them again.
What size socket did you use for the back speaker
I’m not sure. I think it was 6mm
The Metra 72-5600 will not fit in my 98 Ford Ranger. I ended up ordering the Metra 72-5512 because even though Amazon claims they won't fit, all the reviewers say Amazon is wrong. I will have to change the female spade connectors as all the reviewers say they are too small for most aftermarket speakers. I got a pair of Rockford Fosgate Punch P1683's and I'm glad I read the reviews for this harness as they all said for those speakers I'd need to change the spade connectors, lol.
I'm sorry if it was previously asked but are all 4 speakers 6x8? I have a '94 that needs new speakers. Thank you. Great vid too!
The fronts are not 6x8.
Yes they should all be 6x8. The front are definitely 6x8.
@@OsvaldoFerrer so are all the speakers 6x8? I’m trying to figure what I need for my. 1995 xlt extended cab. Cant find any information online.
@@Jaxin-mk6tz I purchased a pair of 6x8 off Amazon and they installed perfectly fine. The rear are the same size. Look at the bolt pattern and you'll see that it's the same as the front.
Alright cool! Thank you!
No prob man. They're good speakers for what they are no problems with mine at all
Good Vid. I have a 95 Ranger that the stereo is completely fried. I have to get new aftermarket radio, new antenna and new speakers. Have advice on installing aftermarket antenna?
+ToddB987 I believe you will have to remove the fender it attaches into, not 100% sure though try a google search and see what comes up
That will really suck.. I'll check it out.
Todd
How's the bass with them?
Not very deep but much better than stock
i got cheap set of pyle 4x6 in my s-10 blazer (98) up in the dash in place of the tweets they sound good for $20 or less off amazon
Had no choice to change mine My still played but every time I hit a bump the face plate pop that thing was holding wire so I just change it out for a Bluetooth Sony one
junk speakers tho...I recommend Pioneer
I have 4 years of car audio installation.
Tip:
You do not need the factory clip you can just cut off the old stock speaker leaving some wire on the harness your cutting off keep the speakers with the plug and little bit of wire. Next connect your new speaker to the wires coming from the door to the new speaker with barrel connectors (very cheap). Now whenever you want to sell your car or take out those speakers out you can cut that speaker connection and reconnect old speaker with barrel connectors. You may heatshrink or electrical tape these connections to make them more weatherproof.
what are the strings for with electrical tape on the ends i got the same ones in my 94 ranger have no clue what their for
What time stamp is it at?
hanksranger around 49 sec when ur getting in to the truck
bradley abrams lol im trying to figure out what your talking about, cant see anything then with electrical tape on them, this has nothing to do with the speakers right? What are the 'strings' attached to?
Nothing their just sitting their its weird i bought my ranger with them in it
Sorry. I see that you mentioned you kept your radio. I feel the same way. If it's not broken why replace it.
where can you get the quick connect wires at? please help!!
Metra 72-5600 Amazon
Lots of reviews keep mentioning issues with polarity.
Hmmm never had any issues with that
Jared Willet year late but I got mine at best buy
Where did u get your speaker harness
amazon metra brand I believe
I have a 1989 Lincoln town car and I am in the process of changing out all the speakers.....and I need some help in finding the SPEAKER Wire harness for it....I went to Amazon and looked up the Metra harness....and it says those won't fix my vehicle....any suggestions????
look your truck came equipped with a garbage can i heard it !
dont cha love it?
You have no idea lolol
What are those Conectores called for the speakers?
I found them on amazon can't remember what they were called exactly just search ford speaker connectors or something
Uhh, the package at around 0:13 says 72-5512, i think 72-5600 might be incorrect
@@JoseRodriguez-dx4pb So whats the bloody answer youve commented more than once. Is it 5512 or 5560
Speaker harness 72-5512 on Amazon
You get what you pay for.
That pun was definitely intended
Perhaps
What are those connectors called? I need to but a set. Thank you!
Metra 72-5600 found on Amazon.
Hank's Small Engine Repair Uhh, the package at around 0:13 says 72-5512, i think 72-5600 might be incorrect
sorry, i hadreplied to another comment lol
Pyle is a lower brand. I see there products in shop. I gotta say there speakers are not bad. Very cheap for what they are. But with my experience and knowledge I really dont recommend using there amplifiers or subwoofers or Car stereos . They have way to much problems.. want amazing cheap car audio? Building a new system? Try out boss audio. They also are a lower brand but they have way better reviews than Pyle.
I sell there products. Sorry lol ment sell not see
Ya I've been happy with these speakers so far. No problems with them though if I ever built a system I would go with quality though.
Lol right? I do budget builds for people all the time that come in my shop. They turn out alright but im with ya there. I am quality all the way
Didn't even demo the speakers.
Ya because you cant get an accurate listen with the cameras microphone, there’s no point. It’s like recording a tv with a camera to show the picture quality. Shouldn’t even have to explain that.