bodgit and leggit garage toyota corolla clutch part 1

bodgit and leggit garage
tips and tricks inside your video hopefully help you
don't forget get your hands dirty
A clutch is a mechanical device that engages and disengages the power transmission, especially from driving shaft to driven shaft.
Clutches are used whenever the transmission of power or motion must be controlled either in amount or over time (e.g., electric screwdrivers limit how much torque is transmitted through use of a clutch; clutches control whether automobiles transmit engine power to the wheels).
In the simplest application, clutches connect and disconnect two rotating shafts (drive shafts or line shafts). In these devices, one shaft is typically attached to an engine or other power unit (the driving member) while the other shaft (the driven member) provides output power for work. While typically the motions involved are rotary, linear clutches are also possible.
In a torque-controlled drill, for instance, one shaft is driven by a motor and the other drives a drill chuck. The clutch connects the two shafts so they may be locked together and spin at the same speed (engaged), locked together but spinning at different speeds (slipping), or unlocked and spinning at different speeds (disengaged).

[@willp7802]

Thanks for letting us know it really can be done without having to drop all the subfames etc as other videos show.
Following your vids have just done my 1.6 corolla clutch without any problem.
Two tips, to remove the driveshafts from the hubs , just undo the three wishbone ball joint bolts and push the wishbone down, the hub can be pulled away and the driveshafts come out easy.
For undoing the driveshaft nuts without air tools or putting a bar against the wheel studs, replace your alloy wheels with the spare steel one which has an open hub centre so you get the socket in there, then lower the tyre onto the floor to provide the resistance / grip.

[@kerrynball2734]

With or without a hoist ?

[@scottaner500]

been waiting for a clutch vid brilliant video very help full

[@scottaner500]

nice one

[@benjaminkyere832]

That's very useful video. Well done for your hard working,Bro.

[@bodgitandleggitgarage]

thanks mate

[@TheSavageGarage]

Nice video bud

[@hassemsadiq]

Fantastic video
I have a rounded hub nut on passenger side can drive shaft/cv joint still be removed from the cup without removing hub nut thanks

[@bodgitandleggitgarage]

boom sorted

[@fiatvauxhall]

grate video.Do you first wire brush and wd40 the nuts and bolts on the struts or do you just windy gun them straight off ?.

[@bodgitandleggitgarage]

Hi mate it depends on what they look like on this one there ok so i just used a gun but if they are bad i will wire brush them and lube them first

[@robertp7287]

I have a bent subframe and need to swap it.. can I just unbolt it from bottom

[@billy123356789]

Can somebody please tell me how many hours labour does it require to replace a 2015 Corolla clutch

[@jusb1066]

what is your vote for most awkward car to work on?

[@Allen187thlivefree]

will this work for corolla sport 5 speed 2004?

[@chloeleedow7250]

Would do they were the same from about 02 to 07 or 03 to 08 bud.

[@Allen187thlivefree]

@@chloeleedow7250 thanks you

[@bradleyjones5932]

the ABS, lol, it's the brake line.

[@bodgitandleggitgarage]

🤣🤣🤣

[@FragGile]

What's the Mileage on it just out of interest?

[@bodgitandleggitgarage]

Paul Wilkinson 128mile