I am personally not a fan of load resisitors once leds are installed into a turn signal. What i did on my miata was modify the flasher relay to have a larger resistor in it and prevent the hyperflash.
@@hasankhalid1204 I followed this thread. It is pretty well documented on the forums, which is why I didn't feel a need to video it. www.clubroadster.net/threads/na-diy-flasher-mod-for-led-bulbs.41048/
Hey, is it possible to get the code from you? I’m trying to fix my 2jackcustoms blinkers but the boards are fried. So now i have to code the blinkers myself. Only problem is that I don’t have a lot of experience with coding. Thanks in advance
This code was specific to the ghozt modules and needed a special connector device to be able to transfer the programming to the ghozt module. You would have to rebuild the lights using the ghozt module in order for it to work.
Two modules. You could definitely run them both off of one controller, however I wanted as little wiring outside of the housings as possible, so I just used two boards, which is definitely not as cost effective.
where did you get the led amber diodes i am trying to build sequential tails for my 2017 avalon and will put them parallel to the factory 1s inside my taillight ..!! pLEASE HELP!! i need them bright!!!
Hey
Are you gonna use load resistors ?
Can please fell me how can u avoid hyper flash without load resistors?
I am personally not a fan of load resisitors once leds are installed into a turn signal. What i did on my miata was modify the flasher relay to have a larger resistor in it and prevent the hyperflash.
@@PeaceParts can you show us or tell us how did you modify the relay and what type of load resistors did u use ?
@@PeaceParts thank you ☺️
@@hasankhalid1204 I followed this thread. It is pretty well documented on the forums, which is why I didn't feel a need to video it.
www.clubroadster.net/threads/na-diy-flasher-mod-for-led-bulbs.41048/
Which resistor u used?
Good job dude. You deserve the chips!
Hey, is it possible to get the code from you? I’m trying to fix my 2jackcustoms blinkers but the boards are fried. So now i have to code the blinkers myself. Only problem is that I don’t have a lot of experience with coding. Thanks in advance
This code was specific to the ghozt modules and needed a special connector device to be able to transfer the programming to the ghozt module. You would have to rebuild the lights using the ghozt module in order for it to work.
Are you using 2 modules. Or running both lights off one??
Two modules. You could definitely run them both off of one controller, however I wanted as little wiring outside of the housings as possible, so I just used two boards, which is definitely not as cost effective.
Peace Parts thanks a lot. I was thinking of using a waterproof project box but I can imagine the amount of wires all over would be unsightly.
where did you get the led amber diodes i am trying to build sequential tails for my 2017 avalon and will put them parallel to the factory 1s inside my taillight ..!! pLEASE HELP!! i need them bright!!!
What flavor of chips you got there??? .....asking for a friend....... lol
Good ole wavy lays😂
This is lit
Indeed it is!😂
Arduino work!