i have been searching for this video for ages. Thank you so much. Which terminal you supplied 12V (Batt)? I see there were multiple pins in that socket. How do you distinguish the pin for + or - ?
Unfortunately I no longer have this pcb, but could suggest couple options: 1. Do not add C1 at all, as you saw on video it was missing on my board and it worked just fine. This is only filter cap. 2. Add random capacity same size capacitor. 3. Cut tracks from near capacitor on your board and measure it with capacitance tester.
Saludos desde México, muy buena información, es posible que envíes el diagrama que elaboraste??? nos serviría de mucho...alimentaste desde el cable a 12v??
Just found old drawing. It might be with mistakes mototomas.lt/harley-davidson-sportster-led-indicators/ But basically PCB is marked with L, H, B+, N, O, R, you can test by applying +12v to B+ and then connect minus to one of board contacts L, H, N, O, R
You are awesome my friend what a great video
Thank you for sharing and it is a very helpful advice to help me to fix my bike by R2 resistor replacement.
Now, it is working.
Kiek kainuoja toks remontas?
What was the voltage you applied to the positive terminal to test the leds?
When tested via wires I used 12 volts. When tested separate LEDs I used low voltage just to check if they work or not ~1.8v., was afraid to burn them.
Did you also set a current limiter or something?@@tmx6666
How did you remove the board from the black enclosure?
Board wasn't glued or something. I just pushed wires from back and helped board to move out with small screwdriver.
@@tmx6666 thanks. I was unable to push mine. i removed some corrosion from the front and it sort of works now.
Great to hear that 👍
Hello sir, could u please let me know what type of LED used for that? Mine left sign is dimmed. Thanks
I do not know exact model, I desoldered used led from some old printer board. Possible LED smd package 3216
@@tmx6666 i see. Thanks sir
Bonjour je rencontre le même souci sur mon sportster est-il possible d'avoir plus d'informations sur le mode d'opération.
Merci
Hello, could you clarify your question?
I am facing same problem. The condition of con is worst, can you plz share circuit diagram and other perameters so that new one can be make.
@@lokeshbharti7388 I have no circuit diagram for it. Only quick drawing made during video.
i have been searching for this video for ages. Thank you so much. Which terminal you supplied 12V (Batt)? I see there were multiple pins in that socket. How do you distinguish the pin for + or - ?
If I remember correctly inside on the pcb board + wire is marked with B+, other wires which goes from Leds apply - to turn them on.
@@tmx6666 ok sounds good. Will check. Thank you so much. This means a lot to me. Subscribed to your channel as well.
Hi, please could somebody tell me the value of C1 capacitor? Thank you.
Unfortunately I no longer have this pcb, but could suggest couple options:
1. Do not add C1 at all, as you saw on video it was missing on my board and it worked just fine. This is only filter cap.
2. Add random capacity same size capacitor.
3. Cut tracks from near capacitor on your board and measure it with capacitance tester.
Saludos desde México, muy buena información, es posible que envíes el diagrama que elaboraste??? nos serviría de mucho...alimentaste desde el cable a 12v??
Just found old drawing. It might be with mistakes mototomas.lt/harley-davidson-sportster-led-indicators/ But basically PCB is marked with L, H, B+, N, O, R, you can test by applying +12v to B+ and then connect minus to one of board contacts L, H, N, O, R