I have 1756-IF6I, I want to injecting 0-10 Volt using Proces Caibrator. I want to see the value come in channel 0 in RSLogix. Which terminal I put my Process Caibrator probe?
Hello Syafrizal: Is the module set up in the configuration screen for Voltage or Current. Your common terminal is wiring arm terminal #5 Your + Voltage terminal for channel 0 is terminal #1. Most of the wiring diagrams for the majority of the modules are contained in the AB manual - "Publication 1756-TD002N-EN-E - November 2021". I would suggest that you find it and download a copy for your reference. Bruce
Hi , i want to calibrate my modules but most of the tabs are not there for my modules such as 1746sc_ni8u and 1746_ni4 only general,connection, and some also have configuration, why no calibration, backplane, module info etc. tabs? thanks
Hello: For the NI4 - the calibration procedure is in the manual for the module. (Publication 1746-UM005B-EN-P - June 2004) For the Spectrum Controls you will need to research on the Spectrum controls site for the proper manual for the module you want. (www.spectrumcontrols.com/). Some of the SLC500 analog modules do a continuous calibration while running. You need to check the manual for each module that you want to check. I hope this helps.
I have a stack myself that I am looking at getting rid of. I appreciate the offer, but will pass on it. FYI - sometimes, but not always, Radwell will buy some of what you have in hand. All depends on how the wind blows past their office window I think. Might be worth doing a list and sending off to them. They pay shipping if they buy it. Low prices but at least it stays out of the landfills.
I have 1756-IF6I, I want to injecting 0-10 Volt using Proces Caibrator. I want to see the value come in channel 0 in RSLogix. Which terminal I put my Process Caibrator probe?
Where process Caibrator source 0-10 Volt
Hello Syafrizal:
Is the module set up in the configuration screen for Voltage or Current.
Your common terminal is wiring arm terminal #5
Your + Voltage terminal for channel 0 is terminal #1.
Most of the wiring diagrams for the majority of the modules are contained in the AB manual - "Publication 1756-TD002N-EN-E - November 2021". I would suggest that you find it and download a copy for your reference.
Bruce
Hi , i want to calibrate my modules but most of the tabs are not there for my modules such as 1746sc_ni8u and 1746_ni4 only general,connection, and some also have configuration, why no calibration, backplane, module info etc. tabs? thanks
Hello:
For the NI4 - the calibration procedure is in the manual for the module. (Publication 1746-UM005B-EN-P - June 2004)
For the Spectrum Controls you will need to research on the Spectrum controls site for the proper manual for the module you want. (www.spectrumcontrols.com/). Some of the SLC500 analog modules do a continuous calibration while running.
You need to check the manual for each module that you want to check.
I hope this helps.
@@abplctestbench759 thanks for the info, much appreciated, keep up the great content!
I'm close to e-wasting a ton of PLC5 stuff. anything you are looking for I can send you? Nothing ethernet capable.
I have a stack myself that I am looking at getting rid of. I appreciate the offer, but will pass on it.
FYI - sometimes, but not always, Radwell will buy some of what you have in hand. All depends on how the wind blows past their office window I think. Might be worth doing a list and sending off to them. They pay shipping if they buy it. Low prices but at least it stays out of the landfills.