Hi sir, if there is steel frame, the top cord is rafter IPE and the bottom cord is RHS, shall we move the bottom cord - RHS- to lower level ? because in reality the IPE - top cord- is connected -say- by end plate with the column! and thus shall this be reflected on sap?? or shall we keep them as it is in sap - all are center to center- without shifting the bottom cord to down by move command
Yes we have to, but in reality you will get some moments no matter if you provide it the best pin joint. For complete courses visit: www.fieldready.co.in/combopreview.php
Etabs will automatically figure out the tension & compression members by the load transfer mechanism. Once its done, it will design the members accordingly as per the type(T or C).
hey fieldReady ..i wand to know the detail analysis and design of steel structure. How much should i pay and what is the mode of payment. I am from Nepal. Thanks
Hi sir, if there is steel frame, the top cord is rafter IPE and the bottom cord is RHS, shall we move the bottom cord - RHS- to lower level ? because in reality the IPE - top cord- is connected -say- by end plate with the column! and thus shall this be reflected on sap?? or shall we keep them as it is in sap - all are center to center- without shifting the bottom cord to down by move command
Best video sir
Do we have to assign any release in the truss member to make it purely axial ?
Also let me know about full course ?
Yes we have to, but in reality you will get some moments no matter if you provide it the best pin joint. For complete courses visit:
www.fieldready.co.in/combopreview.php
THANKS
How to assign windload on 1 slope roof shed type. Where do you locate windward and leeward?
Hello Kelvin for complete info on Wind Forces visit: www.fieldready.co.in
Which one is best for deign of steel structure, sap200 or etabs?
Hello Saugat, For Steel Analysis & Design: Etabs, Staad pro or SAP2000 any one of these. For Steel connections: Staad RAM software.
How to define truss members as compression/tension members in etabs
Etabs will automatically figure out the tension & compression members by the load transfer mechanism. Once its done, it will design the members accordingly as per the type(T or C).
ok
YOUR TUTORIAL in light speed
Complete slow speed available at
www.fieldready.co.in/combopreview.php
hey fieldReady ..i wand to know the detail analysis and design of steel structure. How much should i pay and what is the mode of payment. I am from Nepal. Thanks
maile ni line khojeko thiya khoi payment method nai mildaina yr yaha bata tww
hi i am from Nepal and i want to purchage this course how can i buy it?
Plz cal 9849152039
Hey brother, did u get this course???
@@water-supply_engineering DON'T BUY IT. IT'S USELESS
@@praveenrajbhandari2298 bro do u have all courses