You just saved me a lot of trouble shooting. Thank you on behalf of my 3 kids and wife for helping me fix the actual problem and not have to pay someone after hours cost to come by and fix my furnace at 10pm.
Just got this code after heavy snow and couldn't figure it out. Turns out a snow drift blocked the exhaust and caused the flame to choke out. Make sure your outdoor exhaust is clear of snow/debris.
So we were getting this error code. We looked at what to do and we couldn't figure it out. Turns out our air filter was clogged and that was the problem. Make sure to also check that,
@@ChrisOfAllTrades propane delivery company just replaced the first stage regulator and we haven't gotten heat since ..these are the two codes we are getting... Is this a coincidence or is their first stage regulator bad/faulty? Our gas water heater and gas emergency wall heater that is non-vented are able to run....
my furnace code 1 blink the 4 long pauses (beep, beeeep, beeeep, beeeep, beeeeep). the inducer turns on but the igniter doesn't 🤷🏽♂️🤷🏽♂️. the inducer turns on, igniter, gas valve then blower.
You just saved me a lot of trouble shooting. Thank you on behalf of my 3 kids and wife for helping me fix the actual problem and not have to pay someone after hours cost to come by and fix my furnace at 10pm.
Just got this code after heavy snow and couldn't figure it out. Turns out a snow drift blocked the exhaust and caused the flame to choke out. Make sure your outdoor exhaust is clear of snow/debris.
I had a blockage between 2 of the burners which caused the flame sensor to detect no flame. Cleaned it out and problem solved.
So we were getting this error code. We looked at what to do and we couldn't figure it out. Turns out our air filter was clogged and that was the problem. Make sure to also check that,
Where can I get a copy of that Trouble Shooting flow chart?
How did you get the burners out to clean them? Any video suggestions ??
Here's one video I used. It's not exactly the same burner as mine but it helped to get me started: th-cam.com/video/6ehk0NZVFcg/w-d-xo.html
do you need to remove the gas distribution pipe?
@@ask43242flight I dont think I did. I think I just bent it out of the way without damaging it
@@ChrisOfAllTrades propane delivery company just replaced the first stage regulator and we haven't gotten heat since ..these are the two codes we are getting...
Is this a coincidence or is their first stage regulator bad/faulty?
Our gas water heater and gas emergency wall heater that is non-vented are able to run....
Are you able to upload that Guide and share it with us?
😊😅
0:53 😅 0:53
0:53 0:53
Thanks - Helped allot.
I have the same furnace. Pray for me sir
my furnace code 1 blink the 4 long pauses (beep, beeeep, beeeep, beeeep, beeeeep). the inducer turns on but the igniter doesn't 🤷🏽♂️🤷🏽♂️.
the inducer turns on, igniter, gas valve then blower.
Awesome!