Vauxhall Insignia replacing the Turbo boost pipe due to a split 2litre diesel A20DTH
ฝัง
- เผยแพร่เมื่อ 13 ก.ย. 2023
- This video is on the Vauxhall (Opel) Insignia with the 2.0 litre diesel engine (A20DTH engine code). A common issue is getting a turbo over/under boost, MAF or other sensor issues where the car goes into limp and the engine management light (EML or MIL) comes on. Normally turning the ignition off and back on it will restore for a short time until you generally accelerate hard and it happens again.
The turbo pipes crack and will allow air to escape causing this fault. Typically the crack/damage will be at the back where you won't see it!
Replacing it for the same pipe from ebay:
www.ebay.co.uk/itm/373819529065
Intercooler Turbo Hose Pipe Fits Vauxhall Insignia Mk1 2.0 CDTI 13242121, 860118
I'd also recommend getting a 75mm jubilee (hose clamp) for the lower end on the 'u-bend' as the original Vauxhall clamp is almost impossible to remove/refit without damage. - ยานยนต์และพาหนะ
Great video. Followed your video and got the pipe in and out no problem. I had an inch and half split in mine. Cleaned pipe and gaffer taped it up for a temporary repair till new pipe comes. Thanks.
Just saved me a turbo replacement, i had it booked in to be replaced as i was told it was that. After watching this i decided to remove pipe and check, it was split and now its running as it should after a temporary repair (new pipe on order). Thanks for the vid 👍👍
Great news Rob, I'm glad it's saved you a bit of an expensive job
Great video thanks
very informational
Wish i saw this b4 i brought a MAF im goin for check for split now
Is this something I’m able to do myself
You mention about the scre you have to undo all the way,and spinning to separate the pipe,do you mean the pipe that joins the bent plastic end
Hi,what were the symptoms before changing pipe. Did the car drive ok . Thanks
Great video. Thanks for detailed explanation. Your Icarsoft CR Pro scan tool looked great. Can you please do a future video on reading “ live data”. i would be particularly interested in your Zafira B(which i have too), which seems to have a problem reading live data on vauxhall/Zafira… I would love to see EGR/ DPF and fuel trim data.. this would make a great video.. thank again, kind regards…
Thanks, yeah the icarsoft is handy. I did a full video on it on my channel TH-cam.com/@junkendriven
But I've not got the zafira any more so can't show you the live data it gives unfortunately
Mine broke off EGR is the pipe the same for my 1.6 cdti 136 ps if not any links.ive looked at lots of different pipes but can’t seem to find the correct 1
You used 2 jubilee clips together,are the single jubilee clips not availible for that size clip
hi, I changed my turbo pipe and the car works fine but the service light is still on my dashboard, how do I clear this?
would a 70mm clamp be ok
No codes on my insignia 2010 diesel and no cracks on boost hose but loses power sometimes and also sounds like an exhaust leak but nothing detected. Dunno what to do. Don't want to get ripped off at Vauxhall garage so still searching for a workshop somewhere who knows what they're doing if you know what I mean
Hi, good video, I have replaced the pipe on my insignia but I’m struggling to put the bottom part back in to the Intercooler connector. Should I unplug the top, so the bottom part gives me some play? How should it connect at the bottom part. Thanks
It was a pain! Yes disconnect the top to get some leverage, once in place try using a pry bar or screwdriver to lever one side of the pipe in. Once one side goes in the other sort of follows.
Good luck!