VORON STEALTH BURNER PRINTING ISSUES SOLVED - PART 3

แชร์
ฝัง
  • เผยแพร่เมื่อ 28 ธ.ค. 2024

ความคิดเห็น • 8

  • @julesvid
    @julesvid 11 หลายเดือนก่อน

    Hello there!
    First of all thank you for your build guide, it was verry helpful!
    Can you please share your config file for comparison? I am building a 2.4 verry similar to yours, the only difference is the can bus board (sbb sb 2209 RP 2040 in my build), the hardware side went silky smood but in the software department i am kind of lost with my basic programming skils.
    Thank you and have great new year!

  • @jameslee6881
    @jameslee6881 3 หลายเดือนก่อน

    Been watching many of your videos do you have a link to the stealthburner display and and installation video to it I like that very much? NICE WORK!!

    • @rent2ownnz
      @rent2ownnz  3 หลายเดือนก่อน +1

      Cheers for the feedback - hope you subbed and liked to get it out there. your question... Are you talking about the Knomi screen on the front of the Print head?

    • @jameslee6881
      @jameslee6881 3 หลายเดือนก่อน

      Yes sir had no idea where to source it not what it was i just started printing my parts for my very first Voron 2.4rev D . I'm utilizing the galieo 2 extruder, titanium backers going with sensorless homing , beefy idlers looking forwardto hearing neck from you ,​@rent2ownnz

    • @jameslee6881
      @jameslee6881 3 หลายเดือนก่อน

      Also will be doing the Cartographer version for z and yes I liked and subscribed.

  • @Krautech
    @Krautech 7 หลายเดือนก่อน

    Did you change your mount for the canbus to toolhead again? looks different. i used the G2E umbilical mount like you did in part 2 but i found i had to loop the cable over to get it in lol, here it looks like youve changed it?

    • @rent2ownnz
      @rent2ownnz  7 หลายเดือนก่อน

      Are you meaning the Galileo 2 mount? or the one shown in this video? I changed the complete head over to G2 and made split system wiring loom ... but just after I had completed that, I found that there was a retainer that worked without any modification at all to my wiring. I call it learning to grow :)

    • @Krautech
      @Krautech 7 หลายเดือนก่อน

      @@rent2ownnz oh yeah for the G2 👍 what retainer was it if you don't mind me asking? Your videos have been so helpful