Siemens S7-1200/1500 PLC SMC memory card, program mode, transfer mode set up. English

[@mortenlund1418]

That was awful helpful. Thanks very very much.
As a sinde note: It is really nice to see that putting in and removing is done your way. The manual spells it out how important it is to first set the plc to stop mode and second switch the mains power supply off, before doing anything with the memory card. : )

[@Blades-fm6ck]

Very helpful, just what I needed to know 👍

[@rafaelmerchioridesouza4619]

Thanks a lot mate! Learning a lot with you!

[@samershurman877]

The transfer mode not working if use to the same but a new PLC, keep blinking (TIA Portal V18) with password and Know-how Protection, any suggestions to solve that matter?

[@sansudhar1]

Gr8 video sir.. learnt something from you. 🤝🤝🤝

[@AP-pg6uf]

Excellent, Very useful video thanks

[@christianvogel6340]

THANK YOU!

[@user-fb1bx3hg4r]

I have same problem with Siemens S7-1500 now we didn't have the MMC, if i buy a new one and then insert into the PLC it can running the PLC or not? or we download first the logic diagram from the PLC using software and change the mode selection?

[@sansudhar1]

After transferring the program to SMC, you do not changed the SMC from transfer mode to program mode.
Is it right ? Do we need to change or not required?

[@framos9991]

Thanks !!!

[@juremales4185]

Where did you aquire that little conveyor model?

[@phellomoalosi]

Can a PLC1515 function without the SMC?

[@bryanestrella4437]

How can you program it via the TIA Portal, PROFINET? SERVO MR-J4

[@IGSElectronics]

Never done that before, so wont be able to help you on this matter.

[@jose3570]

what is the purpose of the SD card?

[@Blades-fm6ck]

It's the means of transferring new code to the PLC.

[@suriyat8773]

Factory reset plc s7-1200