Nice job liked the vid just recently my son's 03 e39 525i started melting cylinder 1 coil and check the wires all good ECU opened it up and had a small burn on a chip Do you suggest getting a used one flashed to my vin and bypass ews? Would like your help and knowledge $95 on eBay unless you sell them maybe I can by from you help needed . 🙏
Is this possible to perform on a 2005 545i or 550i ? Please respond Also can you make a video of how make all the new modules put into the car work with the dme please help!!!!!
Whoa... wait a minute. Are you doing this over the ODBII port? K9 port? How? Thanks.
So there is no need to enter the bootmode with grounding a pin on the ecu?
Thanks so much for the vid. Worked perfectly for me👍🏾
Nice job liked the vid just recently my son's 03 e39 525i started melting cylinder 1 coil and check the wires all good ECU opened it up and had a small burn on a chip
Do you suggest getting a used one flashed to my vin and bypass ews? Would like your help and knowledge $95 on eBay unless you sell them maybe I can by from you help needed .
🙏
Is this possible to perform on a 2005 545i or 550i ? Please respond Also can you make a video of how make all the new modules put into the car work with the dme please help!!!!!
What kind of cable do I need for this?
you need K9 cable
@@SadnessRoblox will the BMW 1.4.0 scanner cable work for this?
I take the same steps and I remove my ews box and the car don’t start no crank nothing hmm
Did you scan using INPA? How did you arrive at EWS being the issue?
The starter impuls goes via de ews i think... so you need to conect the two bigger wires that run to the ews ( i think)