INTERLEAVED BOOST CONVERTER | MATLAB SIMULATION | TECH SIMULATOR

In this video, i am explaining about the MATLAB simulation of interleaved boost converter. I have also explained the design of the circuit and control methods used for the closed loop simulation of the circuit.
Feel free to post your doubts in the comment section. For any other clarifications you can contact me at [e-mail].
If you like my work, please consider subscribing to this channel. Thanks for watching.

[@arthurm7846]

Your videos are gold! Thanks for sharing!

[@phamvanhoang4473]

Thanks for sharing.

[@supea287]

Can you make a Simulink Interleaved Boost Converter PV MPPT Tutorial as well please?
🙋

[@TechSimulator]

will try

[@supea287]

Hi, can you use PV array to do the interleaved simulation please?

[@TechSimulator]

yes

[@mayursalunke6052]

very nice and help full please upload different electric vehicle converters simulation videos

[@TechSimulator]

We will try

[@GuttiOmSuraj]

If i want to do with three switches then how to configure the repeating sequence

[@TechSimulator]

Phase shift each carrier by 120 degree

[@GuttiOmSuraj]

@@TechSimulator Can't we not do by this repeating sequence
phase shift carrier i did

[@yesitsme1172]

Can you upload a video of explaining how this controller part work?

[@TechSimulator]

will try

[@usmanagani7496]

@@TechSimulator how about the controller sir?

[@ArchanaKumari-je6wh]

after controller we get duty u again using controller, can u clear my doubt?

[@mustafaadil5565]

hello sir, i have a question... how did u get the value of capacitor as 2000 micro?

[@TechSimulator]

not calculated value

[@RaviKiran-d8h]

Sir is there any research article or pdf for this sir

[@TechSimulator]

My simulations are not based on any reference paper. i am just sharing my knowledge. But still you can get related papers from internet.

[@suryadeeptiwari2611]

Hello Tech Simulator, I was designing this converter and I wanted the current output of 950 A and voltage of 1200 V, i have designed all the other parameters but i am facing problem in the control circuit. Could you please help me out

[@sandeepkumar-qi5uw]

did you get your issue resolved?

[@deepakm.k2193]

Please do the simulation of LLC resonant converter

[@jiefang11]

For the small current 20kHz may better.

[@The_icy_fire]

in the battery charging circuits of electric vehicles, we use this type of PFC circuit to improve the power factor and we use another boost converter to adapt the output voltage to the charging voltage of the batteries (ex: 400V) . But you with your simulation you have 400V at the output, why using another Boost converter is it necessary, or we can limit ourselves to the use of this PFC to charge the battery at 400V ?
Please answer me, because I need it, it's for an internship

[@TechSimulator]

my battery voltage is different