Restoration of old Fan heater
ฝัง
- เผยแพร่เมื่อ 3 มิ.ย. 2023
- In this video, I'm restoration an old fan heater, probably from the 1970s. Fan heater with an interesting design with a lot of elements. fan made without plastic elements, of course with the exception of electricity.
#Restoration
Don't forget to like and subscribe if you like it. I would be glad.
Thank you for watching. - วิทยาศาสตร์และเทคโนโลยี
Nice restoration, would have liked to have seen more of the cleaning processes. Very nice to see the re-use even of nuts and bolts.
Thank you, I'm glad you enjoyed it. I try to use the original parts as much as possible.
Probably the best heater refurbishing video I've seen yet. You refurbished every part and that makes it tops! Thumbs Up!
I refurbish as many original parts as possible, only replaced the electrical part as the cables looked bad. I'm glad you like it. Thanks
Jesus 100c air output 🤣 lethal stuff
🤣
I have cleaned a fan heater for my neighbour, that had a similar style to this ~ rectangular unit, bar foot and side dial, the only difference with hers is that; the tangential fan is inverted and the air is drawn in a vent in the top of the cover, the impeller is plastic, deluxe functions ~ dial had 5 positions = high/low speed fan, high-ll/low-l heater and a thermostat. The only awkward thing with hers was how the mains lead went through the housing - into a perished grommet > a hole in the cover [not an arched slot like you had] = the wire got bent on removing the cover as to how close the strain-relief clamp was to the hole, a screw (in a slot) was loosened under the thermostat to push it into the heater so it’s wheel would clear the slot hole in the cover for removing and the dial was pulled off. I didn’t elaborately/completely dismantle it not like you did, l removed the cover and was amused with the amount of dust that had coated the inside of the chassis, I opened the bottom sash on my window and put the chassis on the outer sill recess of the house and got an electric air-bed inflater and blew the dust out with it, and was amazed at how effective it was and the dust cloud I had made. I also removed the impeller to oil it’s bearing and took apart the motor to [again] oil it’s bearings [these need to be removed > heated and pickled in oil to efficiently lubricate them] l then reassembled the fan heater and inadvertently bent-twisted the wire inside the the cover (it survived the ordeal with some chafing from the hole) and managed to straighten it out. I then tested the heater and it worked as intended
I congratulate you on a successful renovation and thank you for your description of the renovation, best regards.
Legal 🔥
Thanks🙂
I love it! Is it for sale? 🙂
It's not for sale, it will be a souvenir, thank you for watching the video, Regards
Iska model kitna hai brother
I bought the Fan heater at an antique market for 5 euros