Zibo 737 - Autoland X-plane 11 Simulator tutorial [Beginner friendly]
ฝัง
- เผยแพร่เมื่อ 21 ต.ค. 2020
- In this video tutorial, I will show you how to perform an Autoland using the Zibo 737 X-plane 11 Simulator.
My goal is to share with you the sequence of the buttons that you need to push in order to set your Zibo 737 X-plane 11 Boeing 737 Auto-Pilot for landing.
I will perform a quick approach cockpit set up so, I will not go in deep through the Approach chart since I made a separate video about that.
If you want to know more about how to read an Approach Chart watch the video below:
• Jeppesen Approach Plat...
In order to perform a successful Autoland, you need to engage the second Autopilot after you engage the Approach.
If you follow my steps you will be able to perform an Autoland using the mouse only.
You also must check that the LAND3 or CMD in green is displayed, also, it is very important to check that at least the FLARE is armed in the FMA of your X-plane Boeing 737.
If one of these indications are not shown you must perform a go-around.
The Auto Land is normally performed when the Visibility is low.
Even if you are performing an Autoland you must be ready to take controls and perform a go-around if anything is wrong.
==============================================================
Disclaimer:
THIS VIDEO IS FOR ENTERTAINMENT PURPOSES ONLY.
NOT FOR REAL-LIFE OPERATIONS.
PLEASE REFER TO THE OFFICIAL MANUAL AND DOCUMENTATION.
==============================================================
![Best Turbulence Penetration Speed Explained - [Boeing 737 X-plane11].](http://i.ytimg.com/vi/2x84ZylBGG4/mqdefault.jpg)
![Best Turbulence Penetration Speed Explained - [Boeing 737 X-plane11].](/img/tr.png)
Comment the video with your questions and thoughts.. Happy landing!!
Very useful video, thanks for sharing with us!
In my Zibo mode make sure the other FD is on as well to perform the CMD B. Without both FD are on I was not able to perform autoland. Just in case if it didn’t work for you!
Great video. When autoland is in roll mode do you have to manually engage reverse thrusters and manually disconnect auto throttle and auto pilot?
Hi, could you make a video about side step maneuver?
If you want to choose Cat 2 approach instead of Cat 3, how would the procedure change?
IN Zibo is misssing at 360 FT RA stabilizer triming...PMDG can simulate it
Hi
Hey I have a question why didn’t you engage the F/O’s F/D
If the autopilot is turned off, (Cat I approach) and the A/T are left on, will the A/T retard the throttles at 27' RA?
Hi
The same explication but about the xplane mobile
Hey this is a late reply, but I'm only having the promt of "Flare" popping up. Is there any reason for this? It's just flaring late and slamming the ground
No g/s is captured in mine... I did everything same as u did...
Can you contact me? I have some serious questions about flying