Have to say.from the way place your camera to techniques and the way showing viewers all are perfect 100% you're smartest instructors on TH-cam (because I always learn mastercam on TH-cam only)thank you
Really appriciate your video Zane just what i needed to feel comfreable into jumping into 3D programming i am already good with standard 2D but this was great.
DON MUMMA Depending on what direction you want the taper (into the floor or out of the floor) You could use a lofted surface at +/-80deg or You could translate the half sphere in the middle up or down along just the Z axis and then create a surface from inner edge to outer edge. (needing a bit a trig to calculate the Z distance for 10deg) Hope that helps!
![ILLSLICK X YOUNGOHM - We're The same [Official Video]](http://i.ytimg.com/vi/yUJNkobYR0E/mqdefault.jpg)
Have to say.from the way place your camera to techniques and the way showing viewers all are perfect 100% you're smartest instructors on TH-cam (because I always learn mastercam on TH-cam only)thank you
I really appreciate it! When I have time I will be making more videos, thanks for watching!
Really appriciate your video Zane just what i needed to feel comfreable into jumping into 3D programming i am already good with standard 2D but this was great.
Great Video!
Again,hope you post more about toolpath 3D.....thanks
really helpful thank you how would you put a 10 degree taper on the floor
DON MUMMA Depending on what direction you want the taper (into the floor or out of the floor) You could use a lofted surface at +/-80deg or You could translate the half sphere in the middle up or down along just the Z axis and then create a surface from inner edge to outer edge. (needing a bit a trig to calculate the Z distance for 10deg) Hope that helps!
thanx Zane I will try it
Thanks man !
Great thanks
Dat is vele beter dat computers van robotcat op machine om beter stukken make, beetje beter in beste makkelijk CIC machine, of haas machine