Honda ADAS multipurpose camera aiming

[@MrFearless84]

What is the distance between the two targets? I read that it is 800mm, but can you confirm that?

[@MarioHernandez-bn6pm]

From what I remember it was 630mm

[@tousshong9438]

You're right, a lot of works but the calibration only takes less then 1 minutes. Someone needs to make some improvement on those tool you purchase to setup the calibration process so it will takes less times and guessing works out of the setup process because of poor tooling aid. I mean, the pole wasn't even fit tight into the stand..you have to use a piece of tape to assist. Those you bought and used are like home made and not precision at all. IF you bought those from Honda, shame one them.

[@maxwellmadison3904]

Those tools are not home made. All that stuff is OE.

[@tousshong9438]

Those camera targets should comes with built in levelers so you just have to tilt and turn it to make the job easier. However, if it's magnetic, you can buy two small leveler with magnetic and place it on the target. Good job.

[@mototaczki]

When I tried to do static on my 2019 oddy hds is looking for center target! What did I missed ? Picture on hds shows round target. How to do it right?

[@MarioHernandez-bn6pm]

@@mototaczki different models can use different targets !! Not all models use this same set of targets obviously

[@mrsharif5431]

Hlw sir how are u, my car problem is STATIC CAMERA AIMING incomplete, my car model 2016 HR-V, can u send me total measurements

[@ghostofsparta2447]

Can you provide the part number of those targets please

[@jorgegrochet1143]

U CAND SEND ME THE MANUAL