[English] Acceptance criteria for DPT and MPT (ASME Section VIII Div 1)

Acceptance criteria for DPT and MPT as per ASME Section VIII Division 1.

[@rajendharbyri7437]

Tq for your efforts, brother please do videos on asme each section clearly

[@bangariprasad73]

Can you pls explain acceptance criteria as per B 31.3

[@trinityworld2650]

Same

[@avitsalutigikar5981]

Please do video on acceptance criteria for visual inspection as per asme sec viii

[@Mstrdj007]

Sir please show linear & Rounded indication on Test piece

[@Funnyvideos-vz9qm]

Useful.....

[@WeldingandNDT]

Thanks. Please visit my website www.weldingandndt.com

[@gopi17296]

Sir why this case of relevant did not come in radiographic test acceptance criteria?

[@abderrahmanebenabdallah672]

thank you very much

[@abhss]

Thank u sir

[@WeldingandNDT]

Thank you. Please visit my website www.weldingandndt.com/

[@sudhakarjodagudri2281]

If four or more rounded indications separated by 1.5mm or greater than 1.5 mm(eg 3,4 or 6mm etc) Then how to evaluate....please let me know

[@snakebaboo4116]

Four or more rounded indications separated by less than or equal to 1.5mm is rejected. If there are separated by more than 1.5mm then it's not applicable. Hope you understand.

[@panneerselvameswaran9754]

How about acceptance criteria from AWS D1. 1

[@ArifHossain-dk5mc]

sir plase make one video, mpi acceptance criteria for aws d1.1 table 6.1

[@saikatroy7646]

Sir kechu suggestions chahiye

[@WeldingandNDT]

Thank you. Please visit my website for notes, videos and other important informations www.weldingandndt.com/

[@nikleshshahu9371]

Acceptance criteria for ut and mpt share or upload please

[@khursedalam2642]

Sir api 650 video banaye