I used 2mm stainless steel screws, I just drilled out one side of the hinges to allow free movement and kept the other side tight so the pin would screw in. However, the design would allow you to use filament as hinge pins as well. In that case, I would drill out one side of the hinge to allow for free movement and then use a drop of CA glue on the other side to affix the pin. Thanks for watching!!
I just noticed a make posted on Thingiverse. It looks like the maker used copper wire as hinge pins and just bended the end a little to keep them in place. Check it out.
Sorry about the sound. I was using some new equipment and the settings were a little off.
I got the older DJI Mavic Pro but this is what i need too, i like the second version of your sunshade.
Time to cad something for it :0)
The CAD was not too difficult on either of these. You shouldn't have too much trouble. Thanks for watching!
Hi, did you print these standing up or laying flat? thank you for the build.
Laying flat. Thanks for watching!
I like design 2 but what do you use for the hinge pins? Thanks for putting these out there 😀
I used 2mm stainless steel screws, I just drilled out one side of the hinges to allow free movement and kept the other side tight so the pin would screw in. However, the design would allow you to use filament as hinge pins as well. In that case, I would drill out one side of the hinge to allow for free movement and then use a drop of CA glue on the other side to affix the pin. Thanks for watching!!
@@Grimm3D awesome, thanks for the info!
I just noticed a make posted on Thingiverse. It looks like the maker used copper wire as hinge pins and just bended the end a little to keep them in place. Check it out.