When setting pins in the holder, always leave the go pin projecting longer than the no go pin. This identifies each end and allows the go pin to check deeper in the hole.
Can't tell for all of them but those angle blocks are made by Dasqua I think, they do the same set, same case but moulded in blue. The thread ring gauge sets could be Dasqua too, they also do the same sets and package them in the same type of cases.
Very nice
Gonna get back to tip of the day content at some point? It’s been 8 months. Leaving me hanging!
Thanks for video as I am a machinest
@Haas NIST Traceable?
According to the website meets ISO 3650
When setting pins in the holder, always leave the go pin projecting longer than the no go pin. This identifies each end and allows the go pin to check deeper in the hole.
Who is making your gages and tools?
Can't tell for all of them but those angle blocks are made by Dasqua I think, they do the same set, same case but moulded in blue. The thread ring gauge sets could be Dasqua too, they also do the same sets and package them in the same type of cases.
how to mirror toolpath programming in milling??