It is safer to keep the closure patch of sleeve at 10 or 2 O'clock because During lowering of pipe the cradle it rolled over the pipe coating so there is no abrasion over the patch. Also their pipe seam is in 10 or 2 O'clock position welded in alternate manners.
This video having so much content with serial wise
🔥 Thanks 🙏🙏🙏
Thank you
Badhiya h learning ke liye
Nice 👍
Knowledgeable 👌
THis video is very helpful.
Good Skill
Good information
Thanks
good jobs and subscribe
5:13 me 50 mm overlap ka matalab kya ha ? HTLP 80 SLEEVE - 3LPE pr overlap hoga bothe pipe ke edge pr ?
Overlap HTLP-80 To company Coated (3LPE ) is 100 mm both side edge.
But at below closure patch/Joint overlap of HTLP-80 is 50 mm.
@@pipelinecgdnetwork1488 thank you very much
Welcome to try TSD Brand HEAT SHRINKABLE SLEEVE.
Ya try again later.
Thanks❤
Instalando cannusa .esa técnica se usa en Colombia
Ya we try to do it.
Why we closed the sleeves at 10 or 2 o clock?
It is safer to keep the closure patch of sleeve at 10 or 2 O'clock because During lowering of pipe the cradle it rolled over the pipe coating so there is no abrasion over the patch.
Also their pipe seam is in 10 or 2 O'clock position welded in alternate manners.
Thank u brother.
Make the Steel line full video, still commissioning .
Sure sir 😊
Bhai haydro test ka full video daal dijiye
Yes sure I upload,but it's take time.
Blasting should be done under closed by hood for safe purpose do not perform in open like this
koi team hai ye kaam krne ko ? hai to no. share karo
Details send kre location salary etc
Kam hai