Pressure Vessel Shell Design as per UG-27 In Solidwork 2016-part-3
ฝัง
- เผยแพร่เมื่อ 15 ต.ค. 2016
- in this video you learn how to make pressure Vessel Shell as per UG-27 and its thickness calculation. in this video you learn about Joint efficiency
Regards
Design Hub
Design Hub
When at 3.06 minutes where the formula is completed the answer is 0.157 inch but you show 0,325 inch after rounding up. So it seems there is a multiplication of 2 before rounding up is this correct? The initial calculation multiplied by 2 which equals 0.314 inch then goes to 3.25 from rounding up? Is this what you did?
good question, i had the same problem. i hope someone replies
@@mahmoudsalem4288 i think because he added the corrosion allowance C.A (0.125in), but why the corrosion allowance in this case equal 0.125in) !!
@@mahmoudsalem4288 my opinion is because the calculation was the minimum thickness and if seen by their planning to design, manual ->PV Elite->acad->solid (make 3d by pv elite) so in PV elite their another variable like safety factor or lifetime
@@b.l.g6786 minimum std CA 3 mm