dfu-util: No DFU capable USB device available [Solved]
ฝัง
- เผยแพร่เมื่อ 31 พ.ค. 2024
- 🤩 How much Arduino can you learn in 7 Days? 👇
bit.ly/7_Day_Arduino_Challenge
**Get the code, transcript, challenges, etc for this lesson on our website**
bit.ly/3En4zOG
Want to learn more? Check out our courses!
bit.ly/3L4Nk8C
_/\\\\\\\\\\\\\_____\\\\\\\\\\\\\\\_____/\\\\\\\\\___
\/\\\/////////\\\_\___\\\///////////_______/\\\\\\\\\\\\\_
\/\\\_______\/\\\__\/\\\____________/\\\/////////\\\
\/\\\\\\\\\\\\\/___\/\\\\\\\\\\\_____\/\\\_______\/\\\
\/\\\/////////_______\/\\\///////________\/\\\\\\\\\\\\\\\
\/\\\_____________\/\\\______________\/\\\/////////\\\
\/\\\_____________\/\\\______________\/\\\_______\/\\\
\/\\\_____________\/\\\\\\\\\\\\\\\____\/\\\_______\/\\\
\///_______________\///////////////_________\///________\///_
We designed this circuit board for beginners!
Kit-On-A-Shield: amzn.to/3lfWClU
FOLLOW US ELSEWHERE
---------------------------------------------------
Facebook: / programmingelectronics...
Twitter: / progelecacademy
Website: www.programmingelectronics.com/
**About Us:**
This Arduino lesson was created by Programming Electronics Academy. We are an online education company who seeks to help people learn about electronics and programming through the ubiquitous Arduino development board.
**We have no affiliation whatsoever with Arduino LLC, other than we think they are cool.**
00:00 The error
00:24 Why this issue?
01:41 Bootloader mode
02:46 troubleshooting
I double click the reset button but the board doesn't wanna go into bootloader mode, the green LED stays on instead of the fading rgb led
This error keeps repeating then it disappears for a while and comes back. I tested on another computer and they don't have that issue. I did updates all of that. Any other tips ?
Same problem happened to me as well. Solution: Start "BOARDS MANAGER" and install latest firmware for "Arduino ESP32 Boards", at least V2.0.13.
Exactly what I was looking for, problem solved. Thank you Sir!
Glad it helped!
I had the same problem but on my giga R1 WIFI. Before I upload a sketch I need to always press my reset button twice, it will turn green. Hit upload and my sketch gets transferred.
this didnt work for me, in the end had to connect B1 to Ground, hit the button, disconnect the ground. it puts the nano in bootloader mode with the LED glowing dimmed red color. THen usee ACM0 port (using ubuntu here)
I tried this and got this error after it tried to upload:
Port monitor error: command 'open' failed: Serial port not found. Could not connect to COM6 serial port.
Any ideas?
I'm running Linux and have the same problem, and nothing seems to work.. Done all your suggestions. Perhaps it's a Linux issue.. Any ideas?
Its showing hard resetting via rts pin
useless