ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
Finally someone using the kor5 correctly other than Titan
A little scary isn’t it. 😎 A friend used a MA Ford 1/8” three flute with coolent holes 1-1/2” deep 79ipm+ on a Okuma 4020.
Had our 560v cut a corner at 1000ipm and blew up an endmill so not so sure it’s for high speed
The machine cut the corner or your software did? It will slightly cut corner depending on the settings, but we have not experienced it doing something that was not programmed.
@@davidodenthal5060 mastercam opti rough. No problem ever cutting corners until we turned up the return feed.
Finally someone using the kor5 correctly other than Titan
A little scary isn’t it. 😎 A friend used a MA Ford 1/8” three flute with coolent holes 1-1/2” deep 79ipm+ on a Okuma 4020.
Had our 560v cut a corner at 1000ipm and blew up an endmill so not so sure it’s for high speed
The machine cut the corner or your software did? It will slightly cut corner depending on the settings, but we have not experienced it doing something that was not programmed.
@@davidodenthal5060 mastercam opti rough. No problem ever cutting corners until we turned up the return feed.