This is a golden video that I'm going to put in my saved folder. One quick question. I have a manual 1992 and am trying to locate the vehicle speed sensor. Can you tell me where that is located? And is that different than the wheel speed sensor? Thank in advance.
@@ozzstars_cars Does that apply to the manual transmission? And since it is press fit, how can I get it out if it needs to be replaced? And where is the wheel speed sensor? Thanks.
Hi, first time C4 lt1 owner on a 92 base vette. I had clutch redone and ebrake as well and now I get asr and abs light on dash. When pulling away in first gear, it wants to pull me back. There's a humming in the back behind me. I'd appreciate any advice. I'm hoping it could be something loose but I sure as heck don't know. Thanks!!
The abs module is located in a compartment behind the drivers seat and probably the strange noise you are hearing. You will need to start diagnosing the issue, possibly a wheel speed sensor. Good luck
Ozzstar thanks. Changed out sensor and no more error code. My car performs better as well. I am getting one more error code on my 96” and that’s a p1441. I replaced gas cap with a new OEM cap, but error code remains. Any ideas? Thanks for your help.
Have you tested and checked the evap purge solenoid? If you find charcoal bits in there let me know? I have some useful video footage never released on YTube that might be useful.
Hey at 3:51 there's a hole on the right that a bolt goes into. What goes there? My grandfather has a 92 Lt1 and came home one day and someone stole his covers. He doesn't know what else they might have taken. Thanks for the info in advance!
At 3:51 in the video. If you stop it right then you'll see a bolt hole next to the throttle body that goes into the top end of motor. Just wondering what goes there. It would be under the Corvette plastic covers.
Is it right next to the bolt that holds the alternator/compressor in place? I've got a spare bolt hole there, seems like it was meant for a different holding arm.
My 1994 c4 corvette runs great but when I go to park it it's been stalling when I driving in my garage but it starts right back up like nothing is wrong any ideas I did change fuel filter ?
My 93 Corvette idles fought when I start it and put into reverse with the AC on. If I turn off the AC it will not die. Could this be a MAP sensor or IAT or Idle air control valve? Thanks.
My 93 wouldn’t start. It just cranks. It sounds like the fuel pump isn’t priming when I move key to run position. I checked fuel pump maxi fuse in engine bay and it’s fine. I also checked the fuses on the dash interior and those are good too. I just need to replace the fuel pump relay under the passenger I/p. If that doesn’t work is there anything else to check before replacing fuel pump?
I have a 91 vette and the coolant gauge doesn't work and on most all occasions it bucks like hell below 2000 rpm when taking off. Once in a grat while it will take off like new and then shortly go back to a NFR special
Check out some cool tools that Ozzstar likes to use: www.amazon.com/shop/ozzstar
Very helpfull video. thanks for putting this one up. C4s are different from anything else. that has to be the cleanest C4 engine bay on the planet!
@alanmckoy1800 not bad for 32.years old.
I appreciate all your videos. they're my first go to when I need to work on my c4
Thanks for the compliment Loyd!
Ozzstar just sux we don't live close. my 92 is pissing me off lol
Very good information- first time -L T-1 -owner-this helps out A lot-Thank You
The LT1 is a good engine and fairly simple to work on.
Very helpful. I inherited my grandpas 96 lt1 with 100k miles... I’m no mechanic but I try my best to keep her running smooth. Fun car to learn on 😂
Enjoy the car and keep your Grandfathers spirit alive. 👍
Thank you man I try my best. It’s all I got from him.. when I was a kid I used to circle it for hours lol
Nice! I knew most but learned a few. It's amazing how much oil will leak out of the intake.
Not only does oil leak but keep in mind that means the engine also has a vacuum leak! Thanks for commenting
Thanks for the 5 cents tour bud!
Trying to keep prices low for ya man. lol Take it easy - Ozz
This is a golden video that I'm going to put in my saved folder. One quick question. I have a manual 1992 and am trying to locate the vehicle speed sensor. Can you tell me where that is located? And is that different than the wheel speed sensor? Thank in advance.
The VSS is pressed fitted into the side of the transmission just beside the driveshaft.
@@ozzstars_cars Does that apply to the manual transmission? And since it is press fit, how can I get it out if it needs to be replaced? And where is the wheel speed sensor? Thanks.
Hi, first time C4 lt1 owner on a 92 base vette. I had clutch redone and ebrake as well and now I get asr and abs light on dash. When pulling away in first gear, it wants to pull me back. There's a humming in the back behind me. I'd appreciate any advice. I'm hoping it could be something loose but I sure as heck don't know. Thanks!!
The abs module is located in a compartment behind the drivers seat and probably the strange noise you are hearing. You will need to start diagnosing the issue, possibly a wheel speed sensor. Good luck
Passenger side top of the radiator there is a coolant level sensor. Knock sensors are on the left and right of the engine near the motor mounts.
Very informative. Could you tell me the O2 Sensor #1 location? My 1996 LT1 keeps throwing the p0134 code. Thanks
O2 sensor #1 is located on the drivers side bank, cylinder 1 side.
Ozzstar thanks. Changed out sensor and no more error code. My car performs better as well.
I am getting one more error code on my 96” and that’s a p1441. I replaced gas cap with a new OEM cap, but error code remains. Any ideas? Thanks for your help.
Have you tested and checked the evap purge solenoid? If you find charcoal bits in there let me know? I have some useful video footage never released on YTube that might be useful.
Hey at 3:51 there's a hole on the right that a bolt goes into. What goes there? My grandfather has a 92 Lt1 and came home one day and someone stole his covers. He doesn't know what else they might have taken. Thanks for the info in advance!
Not sure what you mean.
At 3:51 in the video. If you stop it right then you'll see a bolt hole next to the throttle body that goes into the top end of motor. Just wondering what goes there. It would be under the Corvette plastic covers.
Is it right next to the bolt that holds the alternator/compressor in place? I've got a spare bolt hole there, seems like it was meant for a different holding arm.
My 1994 c4 corvette runs great but when I go to park it it's been stalling when I driving in my garage but it starts right back up like nothing is wrong any ideas I did change fuel filter ?
It could be vacuum leak, ICM or a fuel injection issue, fuel pressure, bad plug or wires, old stale fuel, bad EGR ...sorry I can't diagnose it online.
Thanks you're right thanks for responding so quickly 👍you're a good dude enjoy watching your videos keep them coming for year's now 😊
Good info.
Thanks Don, appreciate the comment- Ozz
My 93 Corvette idles fought when I start it and put into reverse with the AC on. If I turn off the AC it will not die. Could this be a MAP sensor or IAT or Idle air control valve? Thanks.
Anything is possible but it's almost impossible for me to diagnose over the internet. Check for a vacuum leak and any trouble codes.
Thanks buddy
Your welcome, thanks for checking out the vid.
My 93 wouldn’t start. It just cranks. It sounds like the fuel pump isn’t priming when I move key to run position. I checked fuel pump maxi fuse in engine bay and it’s fine. I also checked the fuses on the dash interior and those are good too. I just need to replace the fuel pump relay under the passenger I/p. If that doesn’t work is there anything else to check before replacing fuel pump?
Test for proper fuel pressure with a gauge. Test and don't guess! Good luck. amzn.to/3YCgYWr
I have a 91 vette and the coolant gauge doesn't work and on most all occasions it bucks like hell below 2000 rpm when taking off. Once in a grat while it will take off like new and then shortly go back to a NFR special
Hey Glen,
On a 1990 C4 - where is the crankshaft position sensor?
Thanks!
There is no CKPS on a stock 1990 LT-1. The engine should have a distributor. Is that your case?
Where is the the serial number on the engine????????? I wanna know if my 95 lt1 engine is orginal.. thanks
What kind of heater is that your using?
It's a Holmes, big box store special.
1992 its a Lt1 C4 only place we haven't looked it where you have to raise the engine a bit
We're is the cam shaft sensor on 85 vet?
There isn't one.
Where is the crankshaft position sensor for a 1990 c4
Location of the crank sensor
where is the crank position sensor and connector
What year make and model of car?
Corvette
Crank sensor