Configuring stateless DHCPv6 on a Cisco router

This video demonstrates how to configure stateless DHCPv6 on a Cisco router. If you have Packet Tracer installed on your system, you can download the Packet Tracer file from the link below and follow along.
www.dropbox.co...

[@MrPrzemo1988]

Hi, how to enable auto config visibility?

[@ddaltonyvcc]

For the client just make sure that it is set to obtain its IPv6 address automatically. For the router, you just need to set the correct flag in the router advertisement. That should be covered in the video.

[@xnm8]

I've got a question?! I have a L3 SWITCH that was turned into a router basically ,i have 2 VLANS on that and i want to configure stateless dhcpv6!And only one link going into lan [g1/0/24 ] How can i do it?

[@ddaltonyvcc]

As long as the layer 3 switch supports IPv6 you should be okay. If I an understanding you correctly, you will need to enable IPv6 on the device and then configure the interface as a routed port and not a switchport, set the IPv6 address on it, and configure it for SLAAC.

[@aaronruiz6852]

Wheres the next vid?

[@ddaltonyvcc]

What are you looking for Aaron?

[@josse16]

Great! man thanks