Woostar controller crazy cart full setup
ฝัง
- เผยแพร่เมื่อ 13 พ.ค. 2023
- How to setup a Woostar controller! The process is a little different if your not using my switch/meter setup but this should give you a good idea, link to my meter setup, chargedup3d.com/products/craz...
Thanks for this video. A life saver. I was super confused on how to handle the 6 pin accelerator pedal connector with the 3 pin controller. But for the switch, what type of connector is that. I need to buy one but don’t know what it’s called 😢
does the woostar controller need an on off switch or can i just have everything plugged in without it
Could i wire the volt meter to the charge port of a 24-36v fast scooters overvolt controller
Hey I have a 36v 800 watt controller and does anyone know how to wire my on/off switch and the pedal
what ist the use of other wires?
Hey been watching this video my controller isn't working thought the throttle was bad, so I changed it got brand new one. I have a woostar 48v 1000w brushed controller. I am running to 20volt batteries to make 40volts the batteries will run the motor without controller when I power up the scooter I get 4.2 volts out of red wire nothing from green wire and the red indicator wire has 40. Volts. Plz help
Hey so I just got the same problem. I measured total battery voltage and it was 36v. I plugged the charger into the batteries and measured 42.6v and the controller suddenly worked. 40v is below the low power cut off (to preserve battery life) I'm guessing.
Where can I purchase? controller.
What battery do you have I can’t fined any with the xt90
I used the XT90 adaptors on a CAO MM 46v battery! Very fast!
I ordered mine from Amazon with the XT90 already connected..
Hey brother! The volt meter indicator you sent me is not lighting. Probably faulty!
Never mind, I did some troubleshooting and connected the voltage display directly to the battery leads, and it works perfectly. The indicator connector obviously didn't provide power to the meter. Thanks. Food for thought!