Lesson# 9: Designing a Beam in Autodesk Robot Structural Analysis

[@borisdjokaboris6424]

Thanks for the tutorial sir ! Can Robot structural analysis do the sizing of beam section (beam geometry optimization)like other softwares?
because those beam geometry(section) are just by guessing right.

[@sahalosman4833]

how to verify the shear torse, if capacity design of the section is too small

[@ivancuaurel1117]

How did you set the presentation format of the reinforcement plans?, What parameters did you use?, Is it possible to send me a template?
Thank you in advance,

[@UmairAhmad-np7yy]

Hi sir
I'm using the same procedure as u followed for beam.reinforcemnt is appearing in "required reinforcemen" but in provided reinforcement calculation the "dimensions cross section is smaller than required reinforcement for flxure or shear"

[@leokhandrorami6828]

Really, you explained well just keep going

[@RadfanOjailah]

+Mohammed Alqadhi thanks, sure I will

[@2000adolf]

ing. radfan ojailah, tiene turorial sobre armado de losas macizas de concreto armado, gracias

[@BoBbYRaNa]

Sir show ni krta last m... Drawing parameters m jaa k set krne k baad krta hai show...

[@vinnowa2516]

I'm trying to follow your tutorial but i can't find grade R or Grade T steel in my software.

[@RadfanOjailah]

You can find them by changing the code of the reinforcing bars from job preferences, just tell me if you didn't find it.

[@wezzaeng4934]

@@RadfanOjailah how can we put the number of bars before the diameter in the bar description in drawing

[@farbodarasteh3351]

Very helpful ,Thanks

[@sobankumarlakshminarayanan5337]

Are we can use the software for Indian standards?

[@RadfanOjailah]

I'm not sure if the Indian code is included within the software. If not, Robot gives you an access to modify one of the included ones and save it as you wish

[@sbr4897]

this is the most important thing, you should elaborate! you re too unprofessional

[@sbr4897]

👎👎👎👎👎👎👎👎👎👎