Mastering Metal Engraving With The Glowforge: A Step-by-step Guide

แชร์
ฝัง
  • เผยแพร่เมื่อ 31 ธ.ค. 2024

ความคิดเห็น • 15

  • @albert-nu3gn
    @albert-nu3gn 2 ปีที่แล้ว +2

    Great video. If you do a lot of metal engraving, there's a spray called Dry Moly Lube that can be used when marking metal and it's so much more affordable, I bought a can off of Amazon for $10.

    • @ashleefalco
      @ashleefalco  2 ปีที่แล้ว

      I have heard about Dry Moly, but I also heard that it's don't good to laser (because the chemicals it releases). not sure how true that is, just have heard that.

  • @debbiemccleery1020
    @debbiemccleery1020 2 หลายเดือนก่อน

    I am attempting to cover up previous engraved writing on a tablet. I've tried several attempt without success. Any advice?

    • @ashleefalco
      @ashleefalco  2 หลายเดือนก่อน

      I don't know if you're going to be able to unless you are doing a new engraving that is larger than the original (like a tattoo cover up)

  • @sha30601
    @sha30601 2 ปีที่แล้ว

    Any suggestions on why once I rinse off the metal marking. My entire design wipes off, so I'm stuck with a blank again 🥺

    • @ashleefalco
      @ashleefalco  2 ปีที่แล้ว +1

      2 things: did you peel off the plastic protector piece? I’ve done that before, it’s thin & clear and easy to miss.
      Second: if you have taken the plastic off, try more power/less speed

  • @francescascholz1919
    @francescascholz1919 10 หลายเดือนก่อน

    Would this work for belt buckles too?

    • @ashleefalco
      @ashleefalco  10 หลายเดือนก่อน

      I don't see why it wouldn't. I would always test the material in a small area before committing to a full design.

  • @HeavenLeeMadeOnEtsy
    @HeavenLeeMadeOnEtsy ปีที่แล้ว

    does this only work with the Plus?

    • @ashleefalco
      @ashleefalco  ปีที่แล้ว

      Nope - will work on all models ❤️

  • @BeThouWhole
    @BeThouWhole ปีที่แล้ว

    Would just covering the metal with vinyl work?

    • @ashleefalco
      @ashleefalco  ปีที่แล้ว

      You totally could put vinyl on metal - but it won’t be permanent

    • @BeThouWhole
      @BeThouWhole ปีที่แล้ว

      @@ashleefalco I mean to cover it for cutting... instead of spraying it.

    • @ashleefalco
      @ashleefalco  ปีที่แล้ว

      ah no. The spray has some sort of reaction to the metal vinyl wouldn't do it. Also - lasering any vinyl is very very bad for you and your machine.

    • @thalegacy6
      @thalegacy6 11 หลายเดือนก่อน

      ​@@ashleefalcoFinally laser safe vinyl!