Avancé Training - Resolving Common Errors - Common Start Up Errors

The 3 most common errors you may encounter starting up your commercial embroidery machine and how to fix them.
1. Emergency Stop
2. Main Access Error
3. Needle Error

[@n2dchaos]

Thank you!!!!

[@margecampbell4667]

dumb no needle errors! Thanks! I have a Pantograms GS1501 & these videos for the Avancé are a huge help

[@ColDesiColman]

Glad they help Marge!

[@daltontyson]

I'm looking for a solution to the above problem. Y limit error.

[@deditor7867]

do you find how too fix the Y Limit Error?

[@margecampbell4667]

You are getting this error because your logo may be too big for the hoop, or you are trying to stitch outside the preset hoop margin. You can either use a bigger hoop, or move the logo around so you stay within the hoop's boundaries.

[@daltontyson]

@@margecampbell4667 this was 3 years ago

[@Kittindian]

I have an error .. My Avance machine stops and said it has a thread break... but no thread is broken.. I hit start and it runs about 6 stitch and same problem again.. no thread broken but it says thread broken..
my top tensions are okay .. this happens on all needles...
What could this be?

[@ColDesiColman]

Julian - you won't get tech support here - email the support department at [e-mail] or visit support.coldesi.com

[@StacySecord]

Bobbin is low or out

[@kolleenmoomey7302]

What about the y limit error

[@deditor7867]

do you find how too fix the Y Limit Error?

[@shivanaik3890]

Niddle possion continues one side run

[@margecampbell4667]

You are getting this error because your logo may be too big for the hoop, or you are trying to stitch outside the preset hoop margin. You can either use a bigger hoop, or move the logo around so you stay within the hoop's boundaries.