Also after the revision in values if the design is unsafe (say I've altered the values of l and t), when we're writing the resulting dimensions (i.e. the last step), which value should we write over there? the revised value right? (the new values of l and t?)
Actually in the R20 series the standard values are given... We can select the next standard value if our diameter doesn't match with any values... In the data book after the last value use the same series with values multiplied by 10 and extend the series...
Sir which Data Book to use for Machine Design ?
Im using PSG Design Databook...
@@themechanicalengineer Kalaikathir Achchagam Publisher ?
Yup..
Also after the revision in values if the design is unsafe (say I've altered the values of l and t), when we're writing the resulting dimensions (i.e. the last step), which value should we write over there? the revised value right? (the new values of l and t?)
Actually we have revised the dimensions... So you should write the new values...
May you please enlighten on how to standardise the shaft diameter using R20 series? Thanks
Actually in the R20 series the standard values are given... We can select the next standard value if our diameter doesn't match with any values... In the data book after the last value use the same series with values multiplied by 10 and extend the series...