Awesome video brother. Exactly what I needed. Very short and to the point. I saved tons of money watching this video and getting my blower running like it should
I replaced my carburetor with a cheap chinese versions (all i could afford at the time) unfortunate the high speed screw on mine does not have a stop. Any tips?
I’d look for instructions from the manufacturer of the carb you used. I get needing to save money but in the long run you’ll be better off with higher quality parts.
i also bought a cheap carb from amazon and both L and H screws don’t stop, i can adjust it to where it idles good but i can never get it to run full throttle, it always bogs down and even when i have it adjusted correctly it just bogs down slowly then i have to adjust it again even though it was just at full throttle perfectly. any advice what i can do too ?
Awesome video brother. Exactly what I needed. Very short and to the point. I saved tons of money watching this video and getting my blower running like it should
Great video bro. Thanks.
Thank you is this the same with the Br 800 c ?
I believe the 800c requires the 5910-890-2307 hex head tool.
What tool did you use for the adjustment?
A small Philips or flathead screwdriver will work.
I replaced my carburetor with a cheap chinese versions (all i could afford at the time) unfortunate the high speed screw on mine does not have a stop. Any tips?
I’d look for instructions from the manufacturer of the carb you used. I get needing to save money but in the long run you’ll be better off with higher quality parts.
i also bought a cheap carb from amazon and both L and H screws don’t stop, i can adjust it to where it idles good but i can never get it to run full throttle, it always bogs down and even when i have it adjusted correctly it just bogs down slowly then i have to adjust it again even though it was just at full throttle perfectly. any advice what i can do too ?
What tool do i need for adjusting ? Part # ?
A small flathead or Philips head screwdriver usually works just fine for these.
hye brother you got a 316 317 or 318 u can sell me runnin or not
I do not
I think your first step is worded wrong, there is no stop turning adjustment counterclockwise. Adjustment screw will fall out
Nvm I’m just dumb 😂
You’re not dumb, we all have our moments. 😆