Great video thanks. You didn’t show removal of the little cross brace bits between the bolts holding down the pump unit cover, but I can’t see that you reinstalled them, was that intentional? Cheers
Do you only need to worry about the impeller pieces being in the lower unit? My impeller is completely disitegrated, and I am not sure if I should check the water tube to the motor. Thanks!
It is likely some pieces have gotten to the tube. Try forcing some compressed air back through the water tell tale fitting. If you feel plenty of aircoming out of the water tube then it should be OK. But I try to find as much of the old impeller that I can
3msht. If you see a hole that looks like the water "tell tale" try cleaning with a piece of seizing wire or torch tip cleaner and the blow compreased air back through it if its clogged.
@@tedsmarinerepair8956 Ah yes, perhaps you know/knew that. But you did not inform the viewer of either thing. I went on line to search for that very fact. But after watching your video, I was none the wiser.
Great video thanks. You didn’t show removal of the little cross brace bits between the bolts holding down the pump unit cover, but I can’t see that you reinstalled them, was that intentional? Cheers
Most helpful ...thank you .. captain lostpuppy and crew 😇😇😇😇😇😇😇♥️🐕
Is there a gasket under the wear plate?
Do you only need to worry about the impeller pieces being in the lower unit? My impeller is completely disitegrated, and I am not sure if I should check the water tube to the motor. Thanks!
It is likely some pieces have gotten to the tube. Try forcing some compressed air back through the water tell tale fitting. If you feel plenty of aircoming out of the water tube then it should be OK. But I try to find as much of the old impeller that I can
@@tedsmarinerepair8956 will do, thank you!
What did you torque those foot bolts to.
Don't forget the two plates on top of the water pump housing before you bolt it back on.
May I ask which model is your? my is 3sf, and i'm looking for the telltale (pee hole)
3msht. If you see a hole that looks like the water "tell tale" try cleaning with a piece of seizing wire or torch tip cleaner and the blow compreased air back through it if its clogged.
Thank you for the video but is better to view it before upload because the camera had bad spot for recording .....but the video still hepfull
Methodical, thanks
You didnt explain which way the impeller fins must lie and rotate. You just pushed it down ???accidentally???.
All outboards rotate clockwise, you might not have noticed but when I push the cover over the impeller I am turning the shaft clockwise.
@@tedsmarinerepair8956
Ah yes, perhaps you know/knew that. But you did not inform the viewer of either thing. I went on line to search for that very fact. But after watching your video, I was none the wiser.
What did you torque the foot bolts to?