RESTORATION OF OLD RUSTY BRUSH CUTTER | Restore japane 2-stroke Mower
ฝัง
- เผยแพร่เมื่อ 22 ธ.ค. 2023
- RESTORATION OF OLD RUSTY BRUSH CUTTER | Restore japane 2-stroke Mower
Currently, we are building a channel to meet the increasing needs of viewers. so our channel will focus on building more engaging and entertaining video content.
_ I hope this is the perfect restoration video for you.
_I hope you find something useful and enjoy this movie! I am pleased with your feedback, advice and suggestions for improvement. !!! sorry for the mistake if i made this restoration !!! thank you !
#diy
#restoration
#Mower - วิทยาศาสตร์และเทคโนโลยี
very nice my friend. greetings from Greece!
👍❤️❤️❤️
日本🇯🇵の田中の製品が大事にされているのに感動🎉しました。
又、サンドブラストや超音波式キャブクリーナー、それと振動による錆び取り機には驚かされました。
錆び取りの後は黒サビにする為の溶剤ですか?
教えてくださいませ😊
なぜかアクセルが左利きになってますね😅😮
惜しくば、エアークリーナー内のスポンジ🧽入れて欲しかったなぁ😂
それと、ギヤ⚙️ヘッド内のグリスアップもやったら良いですよ❤🎉😊
👍👍👍
I guess they just throw their trash anywhere they want to. lol
Why is there always salt on these things in these channels? Why not restore an old tool, there's alot of them around. No need to smear dirt and salt water all over them to make them "rustier".
ES MUY GRACIOSO EL ACTING DEL TIPO CAMINANDO POR AHI Y ENCONTRANDO ALGO PARA RESTAURAR
I'm amazed all the working stuff just thrown away in so many videos
Покрасить бак это гениальное решения 😂 видно сколько осталось топливо😂😂😂
👍🤣🤣
Вот это удивительная африка, из земли кусторезы вылезают
If you didn’t leave it outside it would’ve been usable from the start,
be carefull, you might fly away with full throttle
Great job. Looks great.
hard working will be successful, keep up good job!
Прямо как на Рублёвке,вещи валяются тут и там не кому не нужны 😅😅😅
Tanaka is the best snipper when it comes down to reliability
This is a very unique cutting machine, very small... What was once a rundown and dirty cutting machine, after being touched by the hands of a restoration expert, the results were very surprising... it looked like new again...
Thank bro 😍👍👍👍
No shit Sherlock 💀💀💀😂😂🤦🏻
Great job on restoring the brush cutter it looks great well done
😍❤️❤️❤️
@@restorationt2
@@restorationt2
Bonjour,
Très belle restauration fait de manière logique avec le matériel nécessaire pour réussir (sableuse, fontaine de nettoyage etc..)
En résumé très professionnel !
Cependant je revient sur certains points !
La peinture du réservoir en plastic cela ne va pas tenir à long terme. L'essence et ces additifs est très corrosif, la peinture va pelé !
Personnellement j'utilise de l'acide citrique 20g par litre d'eau, cela nettoie et élimine les dépôts et même blanchit le plastique en l'immersion pendant 24 heures.
Ensuite les durites qui sont à remplacé, au remontage on les voient poreuses. Elles se dégrade et les particules finiront pas encrasser le carburateur.
Pour finir le carburateur, si l'ultrason est le meilleur moyens pour le nettoyé en profondeur, il manque un démontage plus poussé et le remplacement des membranes n'étaient pas un luxe.
Au final votre rénovation est un succès et pour cela je vous dît bravo !👏👏👍👍
Great video bro. I'm a big proponant for having the right tools for the right job and man, you have a fantastic set up. Everything in the right place to get the job done right the first time. Really great video to watch, thanks!
Great job, on the restore!, now the brush cutter will have many,many more years of service 😁 instead of going to a landfill!
👍👍👍
Герметиком смазывать не надо было ну а так то хорошо я 5 лет их уже чиню
Nice job.I like your part’s cleaning station,clever idea !
Nice work! greetings from Germany ❤
Thank you 👍
Protege tu rostro en todo momento no dudo de tu reparación sólo hay que estar protegiendo la vista
Te felicito por la creatividad del pincel con la manguera y la bomba para verter el combustible para limpiar las partes del motor!!!! Un gran saludo-
Vilket fantastiskt jobb du gjorde det är riktigt riktigt roligt att se människor som kan meka med allt och få igång de igen sådan folk som du skulle finnas i mitt hemland för många mekaniker i Sverige håller kvar sina maskiner 1 kanske 20 år sen skrota de jag antar att du är i från Thailand? Tack för denna videon med denna filmen 👍👏❤️
Brother, you are right, 🙂👍 only the last part was very funny. 😂😂
🤪🤣🤣
Great job,never saw a weedeater run on beer!!!!
Thank bro 😍❤️❤️❤️
It was very beautiful, congratulations
😍😍😍
Excelente restaurador de maquinas
Thank bro 😍
very good video
Thank you 👍
Great restoration 😊
At least he found the most reliable brush cuter ever
Honda all the way mate
Good job
😊
I also repair computers. I see you did very well. Thank you for your hard work. congratulations for such great intelligence and effort,👍👍👍🙏
Great job my friend, keep it up 👍👍
👍👍👍
Nice drama..😂😂
Restaurada roçadeira 😉
Tank's Nice video
ohh look at that what i just so happened to find while i was just on a stroll😋
😍❤️❤️❤️
Me encanta como lo restaura
Good restoration, but I'm surprised that the carburettor was not stripped and jets cleaned. In use, the blade speed seems very slow (it might be due to the camera frame rate) and seems to slow even more when cutting. Perhaps check that the clutch is gripping properly.
Partly due to the aspect ratio, along with the fact that the grass is very soft, I run at low speed to save fuel.👍👍👍
wead wacker carburetors dont really have removable jets bro its all diaphrams and he did strip it and clean it and replace the diaphrams its not like a dirtbike carb
Bravissimo 👏 complimenti 👏👏👍
Thank bro 😍
this is magnificent
Should have at least put crank seals init
He knew exactly where to go and where he was, this is a fake for likes gentlemen 😅😅😅😅
Super jest to odrestaurowane ta stara i zabytkowa kosa spalinowa pozdrawiam Mile i serdecznie 👍👍👍👍
Thank bro ❤️❤️
excelente trabajo lo felicito desde chile
Thank bro 😍😍
А как может заржаветь алюминий, пластик и резина?😂
Ну если ее обоссать то все может быть 😂
У них и сапоги будут ржаветь 😂
@@Denis-93 это точно 😂
она не ржавая,а в г о вне)))))))))
Có vụ máy mà bỏ vậy 😂😂😂
Gosto muito de ver este tipo de video so nao me conformo em ver tanto serviço pra montar e nao ser trocado rolamentos e nem a vela mas gosto muito esse tipo de serviços
Awesome job
Thank you verymuch 😍
@@restorationt2 your welcome
Well done my friend, from, Bayamo, Cuba
Hi. Do you speak Spanish?
Молодец мужик работает дома не сидит
Why paint the tank when the paint is going to come off
Малыш,❤❤❤рада видеть тебя.
Thank you 😍
Такое чуство что перепутали начало и конец видео
bon travail bonne vidéo
Да нет это ерунда какая-то 25- 30 кубиков петрушку только стричь в огороде А тут ещё такая мотыга приделана тяжелая под 2.5 кг и движок не может нормально тянуть эту кочергу.если катушку поставить и намотать леску 4 мм он будет захлебываться😂
Não botou nem uma espuma como filtro de ar do carburador?
Great job 👍🏽 well done 💯✅
I have a question 🤔 What's that light 🔵 blue colour liquid 22:22
👍👍
Tell me what's that liquid
I hope that pain holds up on the plastic paint
Resting oldju
Junk ❤
nem sei quem e jon lenu
Le tiene que cambiar el embriage.
Air filter: yes 😂😂😂🤦🏻🤦🏻🤦🏻🤦🏻
Good job
❤️❤️😍😍
Nhìn là biết dân không chuyên rồi lắp còn lỗi quá nhiều 😂😂
Muito bom mesmo gostei 👏👏🇧🇷👍
THANK YOU 🥰
Is useful to power wash the it before you take it apart
Salve a te ragazzo prodigio sei molto bravo nello smontaggio e assemblaggio, una cosa chiedo che polvere è quella in acqua? Ciao alla prossima. Saluti dal nord Salento Puglia (ITA) 😳😁😉✌️
Thank bro 👍👍👍
Aku suka
Prvo propadne pumpica i crijeva za benzin ,Membrane su tvrde,lijepo uradjeno ali je laz da je slucajno pronadjen.
i need a starter for this model
can you send me one ?
Muito bom
aqui e brasil💪
👍👍
De ley amigo ybale que sos con la guadaña capo de como nuevo quedo amigo
Thank you bro 👍👍
Alguien me puede explicar cómo es que el penetrante( WD40) floja los tornillos sin llegar a la rosca del tornillo?😅
tu no ves que baje, pero cuando le colocas en la cabeza al tornillo o en los laterales, en fluido va bajando poco a poco hasta llegar al final de la rosca.
あんな所に放置してあるの有り得ない態とらしい動画
What's the problem with a brush cutter that produces a nearly unseen spark or sometimes it spark and sometimes not?
love your work, but where did u buy that spanner ....?
Thank you, you are doing great job. I want to know how much for Japanese 2-stroke bush cutter machine?
Thank you, I will keep it as a souvenir 😍👌👌
жаль что ето постанова
Que es el líquido azul que usas en los tornillos?
Colorant for snails 👍
И на Али экспресс 😂😂😂
Le renvoi d'angle doit être mort 😂
Top brazil
😍🎉👍👍
👏👏👏👏👏👏💯💯💯💯💯👍👌🇧🇷🇧🇷
😍😍👌👌
Ущільнювачі колінчастого валу не замінив.
👍👍
Піду і я кусторєз пошукаю😂
my name is jorjão
👍👍
This guy know how to restore but clearly not how to cut grass :D
9iiii❤
No se parece falso rik 😂😂😂
,👌
😍😍
Pense em mentiroso 😂
TNK 356
Me lo regali
This video is kinda fake because plastic CANNOT rust and this looks VERY staged
Not rust gas treatment stain.
This is fake you can see that gas tanks don’t rust cuz they are not a metal fuel tank
Even that I agree with you, I believe it is not rust, it is colour staining from old fuel-oil mix residue.
I have seen a lot of fake videos, I think that it is legit.
The gas tank is plastic
Even plastics are affected by chemical stains when not regularly cleaned, yes that is not pure rust but a combination of rust, dust and chemicals that somewhat reacted to the plastic. But I must say that restoration is legit and expertly made.