I Have learned so much from you. I work for a manufacturing, design and programming company and they have been looking at my work lately( everything i earned from you sir) and they just asked me if i wanted to join the design department and which obviously pays more. I told them to give me a couple of weeks to finish the course and review everything again and they agreed. THANK YOU SIR, THANK YOU.
Love it all! However, on this on when I changed the dimensions in the end, the back part did not update as yours. Any idea of where I went wrong? Thanks :)
The document unit system behavior is driving me nuts. I have an Assembly template saved as IPS but when I want to create new component inside Assembly the units change back to MMGS. If I forget to change it before putting down dimensions the sketch gets borked.
Hi, Thanks for a great video series! I have been doing solidworks for a couple of years and consider myself fairly proficient but everytime I get into "top down" and try to add a feature such as your flange on the front of the camera, the extrude boss base tool will not light up (or the revolve boss base) even though the extrude cut WIll light up. This only seems to happen in the assembly mode. If I go to the part, everything works fine . Any suggestions? Andy
I Have learned so much from you. I work for a manufacturing, design and programming company and they have been looking at my work lately( everything i earned from you sir) and they just asked me if i wanted to join the design department and which obviously pays more. I told them to give me a couple of weeks to finish the course and review everything again and they agreed. THANK YOU SIR, THANK YOU.
Love it all! However, on this on when I changed the dimensions in the end, the back part did not update as yours. Any idea of where I went wrong? Thanks :)
Thank you Sir!
The document unit system behavior is driving me nuts. I have an Assembly template saved as IPS but when I want to create new component inside Assembly the units change back to MMGS. If I forget to change it before putting down dimensions the sketch gets borked.
i cannot find the thin feature :(
Hi,
Thanks for a great video series!
I have been doing solidworks for a couple of years and consider myself fairly proficient but everytime I get into "top down" and try to add a feature such as your flange on the front of the camera, the extrude boss base tool will not light up (or the revolve boss base) even though the extrude cut WIll light up. This only seems to happen in the assembly mode. If I go to the part, everything works fine . Any suggestions?
Andy
Thanks for the great tutorials! I keep getting stuck on the step to create the lip for the rear reservoir: when I try to create the
😁
hey vertanux1 did you watch morbius? what did you think about the movie? what was your favorite part?