pl162t water level probe problem- steam boiler overfilling

[@davidengel7321]

Thank you for this video. I had the issue with the probe that it was inside the plastic. Now my Bianca is fixed with no money spent!

[@hristiyanpetrov5622]

Hello, yesterday my Bianca V3 blowed the SSR. I have replaced it with CRYDOM as I had it in hand until the original comes from the seller. Parameters are the same, looking into it I even believe is of higher quality.
After replacing it I start the machine and the Steam Boiler now overfilling. I have took out the water level probe to see, all seemed good there was 1cm or so naked metal. Than I grounded the probe wire to the body if the machine, but the boiler still was overfilling.
Than I went to check the connections to the main board de-attached and re-attached the cable booth all was good. I tested the wire with meeter signal was there.
From there I checked the Solenoids - both of them were clean (machine is 1 year old). I checked the smaller Solenoid was reading 240 V when turned the machine on?
What else may be blowed with SSR relay in order boiler to keep filling ?
Can it because the SSR I have now is not the same? I dont think so but... cannot think of something else.

[@ShalevAbuhatzeira]

What is the PN for the Mara X / Bianca water level probe gasket which come somtimes in white or green foam metarial? I need to replace it in my bianca.

[@lelitinsider2977]

teflon gasket (white) for the water level probe

[@ShalevAbuhatzeira]

@@lelitinsider2977 thanks. Which diameter and thikness?

[@lelitinsider2977]

@@ShalevAbuhatzeira 13x17 h 2.5mm, or use some teflon tape, it works

[@achitofernandez2570]

I heard that the problem full boiler... is a usually problem in MaraX...
few friends have the problem... the waranty change the machine

[@ekinnyc]

Is there a way to drain the steam boiler without turning the machine over? I had this issue, fixed by replacing the level sensor. Was fine, until I drained the service boiler by opening the hot water tap, then when I added new water, I have this problem again

[@lelitinsider2977]

hi, with bianca , if you drain the water from the water tap, you remove complitely the water, look the boiler inside th-cam.com/video/H7eh289nUh4/w-d-xo.html

[@lelitinsider2977]

how old is your machine? if you need help , to be faster please send a video at [e-mail]

[@pilosopo25]

Where can I buy that water level probe?

[@lelitinsider2977]

from your reseller in your country! or ylu have to look for a reseller lelit

[@hariswiranata9894]

My bianca only reach 2 bar and water debit from screen/head only flow out a bit. What is the problem?

[@lelitinsider2977]

there may be dirt in the flow control, contact your dealer or email [e-mail] for more information.

[@note2you]

thanks for share