Another grrreat idea from Nissan. /s. Rather than replace seals/gaskets, replace the whole valve cover. ugh smh. Think this one might be out of my diy ability range. Imo, owner here fortunate to have found a tech to properly do the job. I will say that engine bay looks very clean.
How many miles were on this car, looks so clean under the hood, was it out of the 5/60 power train warranty. Dumb design by Nissan for the engine mounts.
All car in Florida looks this clean .. even cars from 1980 looks as good … this is 2014 model it has over 100k miles .. yes design is dumb but job is not bad as it looks
Another grrreat idea from Nissan. /s. Rather than replace seals/gaskets, replace the whole valve cover. ugh smh. Think this one might be out of my diy ability range. Imo, owner here fortunate to have found a tech to properly do the job. I will say that engine bay looks very clean.
Thank you … we have 20-30 year old cars look the same … cars in Florida don’t rust because no snow lol
When replacing the valve cover should I use silicone on the new gasket or not? Thanks for the nice video.
no ,but its ok to use little bit on corners or to hold new gasket
How many miles were on this car, looks so clean under the hood, was it out of the 5/60 power train warranty. Dumb design by Nissan for the engine mounts.
All car in Florida looks this clean .. even cars from 1980 looks as good … this is 2014 model it has over 100k miles .. yes design is dumb but job is not bad as it looks