DALI Lighting Automation with Codesys

Using the WAGO-I/O-SYSTEM to run a basic DALI lighting setup with WINSTA cabling.
Wago Controller - [750-880]
DALI Master module - [753-647]
Power Measurement module - [750-494]

[@tiagodelararibeiro8768]

Hello! I can use this driver DALI for dimer power suply to 0 - 12V? its for a led light.

[@wagoeugene8261]

Hi Tiago, Are your Dali drivers running on 12VDC? In the setup above our DALI drivers are running on 24VDC which is the same voltage for the automation setup. If your Dali drivers are 12VDC all you need to do is add a different power supply (12VDC - which we have in our range) to power your drivers and a separate power supply (24VDC) to power the node.

[@tiagodelararibeiro8768]

My LED's are 12V, the module I/O is with 24V,the drivers supply 127V, DALI+ DALI- and Vout max 150V...

[@wagoeugene8261]

Yes, as long as you have a separate power supply for your LED drivers you can still use our Dali Card. The Dali + and Dali - are just signal wires, so the voltage doesn't matter.

[@guybramwells]

I have dimmable sal pannels. Compatible with Dali. Acording to the manufacturer. What is involved in installing the Dali driver? Is it a simple wiring job. Or does the panel need to opened?

[@avsantos76]

The multisensor is from TRIDONIC? Did you use some tool to configure the multisensor or you only use Codsys? Thank you

[@wagoeugene8261]

Hi, to configure the sensors and lights you use the wago dali program. As long as the data lines are fed into the module, you can program it this way