Hi there, thanks for reaching out! Please refer to the following link on how to use the Password Settings on a CBS Switch through the CLI: cs.co/6052O48Su. Let us know if this helps!
Unplug the Switch Boot the Switch look in Booting Process Press enter for Stopping the Process Choose in the Menue: Password Recovery Procedure CLI: en conf t username cisco password ciscopassword12345 confirm with YES reboot CLI: no service password recovery service password recovery
great well done😀
When you perform the password recovery would this wipe out the switch configuration?
Good question! This process does not wipe out the switch configuration.
😊😊😍
Is this the same on the SG350?
Password Recovery for SG350X via CLI: cs.co/6054JtyQG
Cbs250, can recovery password?
Hi there, thanks for reaching out! Please refer to the following link on how to use the Password Settings on a CBS Switch through the CLI: cs.co/6052O48Su. Let us know if this helps!
So you are showing people how to hack your switches?
Still living in prehistoric times with unnecessary CLI commands. Get rid of CLI on these basic devices. Not needed.
Hey the CLI saved my switch when I put bad firmware on it. Thanks to the CLI I was able to revert back to the inactive image.
Unplug the Switch
Boot the Switch
look in Booting Process
Press enter for Stopping the Process
Choose in the Menue: Password Recovery Procedure
CLI:
en
conf t
username cisco password ciscopassword12345
confirm with YES
reboot
CLI:
no service password recovery
service password recovery
Great videos, annoying music