The fourth and final in a series of video clips that will help make installation of Franke products faster and easier. Visit our website at: www.franke.co.uk
If I fit new sinks to new worktops this is a no brainer, they are so easy to fit and make for such a good job, I would not use the old clips but a few important things to note I only fit to new worktops, I would not use a jigsaw to hack out the opening required, I use tracks with plunge saw for the perfect finish. Always use a tap base support or make a reinforced panel to ensure the tap is fixed solid and not flexing on the stainless sink. Before anyone thinks about fitting a new sink into an old worktop its vital all apertures and dimensions have been checked to ensure you are not going to be left with gaps. The most important thing is patience and double check before cutting anything. :-)
As Timonious G said these Franke clip in sinks are appalling knowing what l know now good old fashioned clips from now on BTW l bought. Franke due to the poor quality of the B&Q Cooke & Lewis tops....fitted a C & L one a few months ago and the are so thin the taps wave all over despite fitting an extended reinforced base to the underneath of the taps
If replacing a sink, do NOT buy one of these clip-in sinks; I got 8 hours invested and still can't get it to fit into the old hole correctly. What a nightmare! Cut a little here, then there and nope, this corner is now off. Gone through two tubes of caulk, all of which is either on my floor or wrapped in drenched towels.
Even the video is good, but we can NOT understand what the worker say. I guess you use the mic from camera (which is far away) instate a mic close to hes mouth. 👎👎👎👎
If I fit new sinks to new worktops this is a no brainer, they are so easy to fit and make for such a good job, I would not use the old clips but a few important things to note I only fit to new worktops, I would not use a jigsaw to hack out the opening required, I use tracks with plunge saw for the perfect finish.
Always use a tap base support or make a reinforced panel to ensure the tap is fixed solid and not flexing on the stainless sink.
Before anyone thinks about fitting a new sink into an old worktop its vital all apertures and dimensions have been checked to ensure you are not going to be left with gaps.
The most important thing is patience and double check before cutting anything. :-)
As Timonious G said these Franke clip in sinks are appalling knowing what l know now good old fashioned clips from now on BTW l bought. Franke due to the poor quality of the B&Q Cooke & Lewis tops....fitted a C & L one a few months ago and the are so thin the taps wave all over despite fitting an extended reinforced base to the underneath of the taps
I agree..
How do you remove it?
Love it
J'aimerai trouver un tutoriel pour placer la bonde...
you need to get a better mike or one that's closer to you, can hardly hear you
Hi may I know what is the model no of the sink please?
Hello. The sink is a Franke Ascona ASX 611 - available in 860mm long and 1000mm long versions.
Thanks for replying, will have a look, it's exciting to have a new kitchen lol
If replacing a sink, do NOT buy one of these clip-in sinks; I got 8 hours invested and still can't get it to fit into the old hole correctly. What a nightmare! Cut a little here, then there and nope, this corner is now off. Gone through two tubes of caulk, all of which is either on my floor or wrapped in drenched towels.
Very good response.
Even the video is good, but we can NOT understand what the worker say. I guess you use the mic from camera (which is far away) instate a mic close to hes mouth. 👎👎👎👎
fack