how is this different from the dt swiss. Also after I went on like my 20th ride, the hub became dead silent. before, i could hear the ratcheting. Is there sand it or is a spring worn? It still works fine though.
yes, but its correct. the left ratchet is driving, the right ratchet is hooked to the hub. its not intuitive. if you look at the mechanism, the freehub pulls the left ratchet to the outside and closer to the right hub. the mechanism is pretty complex. really not stupid, fancy mechanics, but complex.
Porém este novo sistema tem esta mola que faz o atracamento ela com tempo perde seu ecoficiente e o cubo perte o atracamanto ou fica mais baixo o som das engrenagens sistema antigo mais novo PELA SHIMANO ja existe isto nos cubos chris King
Olá bom dia meu cubo deore xt 12velocidades com sistema micro splaine apresento vários plobemas foi acionada a garantia me mandaram outro cubo rodei alguns dias e deu defeito novamente agora a oggi quer me dar um cubo MT 510 bem inferior ao xt o que devo fazer
Estou pedindo garantia do meu também. Pedi um XTR, mas parece que esta em falta no mercado. Se me mandarem um XT novamente, vou tentar alcançar quilometragem rápido pra ver se vai dar defeito novamente.
What problem did you have? and what have happened again and how many kilometers? the same thing happened to me but they put a gasket on the cassette and greased it
Isn't this a very very similar copy of Chris King's R45? Also are these Shimano's animations? the pawl and tooth animation is spinning in the wrong direction. Anywho.. its going to be the best hubs in the world. Quiet hubs FTW
I like the noise a freewheel makes, it alerts hikes/runners that someone is coming up behind them, (even before I can see them at times), and that splined hub doen't look like such a good idea, even when I ran a 36 granny gear on the rear I would chew the splines up on a lightweight hub in a month, having to get the cassette off with a hammer, with a 51 tooth, and my torque I wouldn't count on it lasting a month..
@@FlimFlamvanHam Hope you're both being sarcastic. Anyway, Don, you don't know the first thing about engineering apparently. The larger the contact area, the lower the force applied to any point.
@@FlimFlamvanHam I usually would have read your comment as sarcastic, but right after reading Don talk about his hub-wrecking torque, wasn't quite sure where I was.
there is something like that in?
is this new shimano xtr m9000 ??????
Have DT:s patent come too an end or what, Mavic is also going DT mode.
how is this different from the dt swiss. Also after I went on like my 20th ride, the hub became dead silent. before, i could hear the ratcheting. Is there sand it or is a spring worn? It still works fine though.
@MJD didn't dt swiss have a patent on it?
Strange the hooking of the ratchet looks on a inverse angle?
yes, but its correct. the left ratchet is driving, the right ratchet is hooked to the hub. its not intuitive. if you look at the mechanism, the freehub pulls the left ratchet to the outside and closer to the right hub. the mechanism is pretty complex. really not stupid, fancy mechanics, but complex.
Porém este novo sistema tem esta mola que faz o atracamento ela com tempo perde seu ecoficiente e o cubo perte o atracamanto ou fica mais baixo o som das engrenagens sistema antigo mais novo PELA SHIMANO ja existe isto nos cubos chris King
O resultado disso tudo ai foi um rangido dos infernos que ate desanima o ciclista...
Olá bom dia meu cubo deore xt 12velocidades com sistema micro splaine apresento vários plobemas foi acionada a garantia me mandaram outro cubo rodei alguns dias e deu defeito novamente agora a oggi quer me dar um cubo MT 510 bem inferior ao xt o que devo fazer
Estou pedindo garantia do meu também. Pedi um XTR, mas parece que esta em falta no mercado. Se me mandarem um XT novamente, vou tentar alcançar quilometragem rápido pra ver se vai dar defeito novamente.
What problem did you have? and what have happened again and how many kilometers? the same thing happened to me but they put a gasket on the cassette and greased it
@@treklocura There is a huge noise when the cube reach 150 km.
Estou com mesmo problema no meu slx 12v parece que tá quebrando tudo
Isn't this a very very similar copy of Chris King's R45? Also are these Shimano's animations? the pawl and tooth animation is spinning in the wrong direction.
Anywho.. its going to be the best hubs in the world. Quiet hubs FTW
there's no contact between the two gears when preloading, which is different from Chris King.
I dont know why cycling industry took so long to make this kind of stuff. Its literally a roller brake with a jaw clutch
I like the noise a freewheel makes, it alerts hikes/runners that someone is coming up behind them, (even before I can see them at times), and that splined hub doen't look like such a good idea, even when I ran a 36 granny gear on the rear I would chew the splines up on a lightweight hub in a month, having to get the cassette off with a hammer, with a 51 tooth, and my torque I wouldn't count on it lasting a month..
Good points Don. Those idiots at Shimano have clearly not given this much thought before implementing on their flagship mtb drivetrain for '19.
@@FlimFlamvanHam Hope you're both being sarcastic.
Anyway, Don, you don't know the first thing about engineering apparently. The larger the contact area, the lower the force applied to any point.
@ Philly C T, of course I’m being bloody sarcastic! It’s Shimano! Some
arm chair engineer knows better: right. Sarcasm again there in last sentence.
@@FlimFlamvanHam I usually would have read your comment as sarcastic, but right after reading Don talk about his hub-wrecking torque, wasn't quite sure where I was.
It's too late when they can hear you, or me.
E uma porcaria esse sistema ai.