The Do's and Don'ts of Industrial Gas Springs
ฝัง
- เผยแพร่เมื่อ 4 ต.ค. 2024
- In this video, we explain all the do's and don'ts of heavy duty gas springs!
Shop gas springs:
www.guden.com/...
About Guden:
Guden has been a leading provider of industrial cabinet and door hardware solutions for over 100 years. Our expansive selection of produce offerings includes heavy duty continuous hinges, butt hinges, slip joint, spring latch and spring loaded hinges, gas springs, dampers, lid supports, handles, latches and so much more! Learn more about continuous door hinge installation.
Quality Mission Statement
The H. A. Guden Co., Inc. Quality Mission Statement reflects the dedication of our employees and management to continual improvement and providing products and services that meet or exceed customer expectations. Now as an employee-owned company, there is even greater pride in continuing the company's philosophy that quality and service is the cornerstone of our uniqueness in our industry.
Visit our Website:
www.guden.com
Follow Us on LinkedIn:
/ h-a-guden-co-
Like us on Facebook:
/ haguden
![เปิดบ้าน พี่ตูน Bodyslam หลังใหม่คนแรก ที่ภูเก็ต l [Nickynachat]](http://i.ytimg.com/vi/flFwcmyDQSk/mqdefault.jpg)
we are Chinese gas spring supplier
your video is perfect, thanks.
Useful video, thanks for the info.
thank u
Wait I'm confused. You say install gas spring ROD END DOWN. Why is the one on my vehicle trunk ROD END UP? Should I go and turn them around to make it correct?
That's rod end down in the position where the lid is at the majority of the time. For example the gas spring used in a trunk of a car is only seen when it is open and it is in that position a very small percent of the time. So when the trunk is closed the rod end is most likely down.
Could you please explain what you mean by not using the gas spring as emotion stop?
You should have something else stopping the full opening of your object being lifted, rather than letting the extremity of the strut (where it can go no further) be the 'stopper'. The wording in the TH-cam clip is 'motion stop' rather than 'emotion'...probably a simple typo.
Are there readily availanle gas springs with a negative internal pressure/suction to want to pull closed as apossed to push open?
GOOD DAY. HOW TO MEASURE THE CORRECT PRESSURE IN THE GAS SPRINGS?
If the inner shaft is bit couple of cm. longer is it possible to cut and put a thread to pit the end ball joint plastic fitting?...as in my case, its 2 cm longer ...thank u for quick response...
WE ARE WORKING USING THIS , BUT WE BELIVE HTE LIFE TIME IS OVER.,.CAN YOU HELP US?
Can gas struts be used in 'tension' mode?
eg. a fold down wall table.
No. Typically you would use a damper. And for that type of application, you would use an extension damper. One of our videos explains the difference between the dampers and gas springs.
i need this gas spring .Can u give me the contact details for buying this.
Can I get a gas spring that can lift 1 tonne?
No, at that point I'd imagine you're looking at hydraulics.
With proper treatment they could last up two years.
Or much longer. Depends on the application and the environment it is operating in. Lots of factors.