Arctic Cat Engine Rebuild Clutch Install Part 3

Installing Clutch housing clutches and belt

[@3vuesaturn]

Hi there.. I just had new seal and bearing installed at dealer in clutch case. I had the old clutch drum housing and shaft put back in. Also new o ring.. now, I just purchased a new drum and shaft and wet clutch. Does the old shaft and housing have to be pressed out and the new pressed in? Dealer said I may ruin the new bearing when removing old shaft.. I literally havent moved the bike since this was done. Just decided at last minute to install all new.

[@mechanicschannel1]

Hi yes you would have to press the drum out of the bearing but if your careful you may be ok but a chance the bearing could get ruined so worst case you’ll need a bearing

[@christoffer9707]

Hi, i am having trouble removing the clutch housing.... do you have any tips on how you did it?

[@mechanicschannel1]

You mean the clutch drum from the bearing

[@mechanicschannel1]

I think I just used a brass hammer and banged it out I bought a new drum anyway so didn’t care about the old one

[@arthurrepass9650]

I cannot find this tool for installing this seal. What else besides the part no. would I need to search for?

[@glen1498]

Where are you located ?

[@arthurrepass9650]

@@glen1498 Virginia

[@glen1498]

@@arthurrepass9650 I forgot where I bought mine but if you want to buy mine I’ll sell it. Thanks

[@arthurrepass9650]

@@glen1498 Not sure if I'll ever have to do this again, BUT how much do you want for it?

[@glen1498]

@@arthurrepass9650 I don’t know I’ll see what I paid for it I think it was like 30 bucks but I’ll check and get back to you.

[@user-ww9oh8gx7i]

Байдену привет передавай