@@xcellfury99 There is a lot of testing that needs to be done rather than just set the highest frequency and send it. I originally tried 500hz for cyclic and 1khz for tail and drained my receiver pack which previously took 10-12 in 2 flights!! I luckily had a programmed low voltage alarm that went off and I landed immediately but I can see that being an issue if you were not paying attention. Additionally, the load on that little 2500mah 2s pack must of been a lot to kill it in about 8 mins. With that said, I can see how people may experience brown outs if running off the ESC. I would not blame the vbar EVO as the issue.
Smokes a lil, don't burn no oil tho.
are you flying on the updated (XXXXX.65) EVO software?
Yes, v7.1.65
@@pgrcadventures1414 hopefully they fixed whatever its making EVOs fail in flight then
@@xcellfury99 There is a lot of testing that needs to be done rather than just set the highest frequency and send it. I originally tried 500hz for cyclic and 1khz for tail and drained my receiver pack which previously took 10-12 in 2 flights!! I luckily had a programmed low voltage alarm that went off and I landed immediately but I can see that being an issue if you were not paying attention. Additionally, the load on that little 2500mah 2s pack must of been a lot to kill it in about 8 mins. With that said, I can see how people may experience brown outs if running off the ESC. I would not blame the vbar EVO as the issue.
How the hell do you do that 🤯
Lots of practice and crashes, thank you!