I have Arturia Audio Fuse Studio. Can I connect two interfaces by adding the Arturia 16Rig interface to my Mac? whether all inputs and outputs in both interfaces will be visible in Audio Fuse Control Center and Ableton. Will it be Plug&Play or do I need to install any additional drivers?
is it possible, to route the different inputs to the individual outputs? example; input 1/2 and 3/4 go to output 3/4, input 7/8 go to output 5/6. ...something like group sends.
It is not possible. I have the 16rig. Outputs can only receive 1 input. i.e output 3/4 can only receive input 1/2. But input 1/2 can go to Output 3/4, 5/6, 7/8, etc.
So, from what I'm gathering, you cannot both listen to audio from your computer _and_ monitor inputs _without_ a daw, which is incredibly disappointing since most interfaces allow this kind of pass through/custom mixes. Please tell me I'm wrong.
@ yes! You can. It’s not very intuitive. But it’s possible. I would need to look at my settings, but I got it working. I wish it just was set up like that by default
Is there an update for the Audiofuse 8pre control center???
What's about Loopback? Does it has internal DSP effects?
proper unit , and so clear explanations
Can someone recommend a good midi control surface with motorized faders that would work well for this? Preferably with knobs for Aux/Pan as well
Console 1 & Console Fader 1 :)
I have Arturia Audio Fuse Studio. Can I connect two interfaces by adding the Arturia 16Rig interface to my Mac? whether all inputs and outputs in both interfaces will be visible in Audio Fuse Control Center and Ableton. Will it be Plug&Play or do I need to install any additional drivers?
@Arturia can U switch presets via MIDI or global key commands?
Still can't figure out how to use the Aux sends. Trying to use with a QuadraVerb and AF in standalone mode.
is it possible, to route the different inputs to the individual outputs? example; input 1/2 and 3/4 go to output 3/4, input 7/8 go to output 5/6. ...something like group sends.
It is not possible. I have the 16rig. Outputs can only receive 1 input. i.e output 3/4 can only receive input 1/2. But input 1/2 can go to Output 3/4, 5/6, 7/8, etc.
So, from what I'm gathering, you cannot both listen to audio from your computer _and_ monitor inputs _without_ a daw, which is incredibly disappointing since most interfaces allow this kind of pass through/custom mixes. Please tell me I'm wrong.
Just got the 16rig. Have you found the answer on this? Very strange if this is not possible. Was very simple on my Focusrite Scarlett.
@ yes! You can. It’s not very intuitive. But it’s possible. I would need to look at my settings, but I got it working. I wish it just was set up like that by default