Ep3 K24 allmotor 1/4 mile Run & dyno
ฝัง
- เผยแพร่เมื่อ 18 ก.ย. 2024
- Intake 4 inch
Throttle Skunk2 74mm
Rbc ported
Head k20Z3
Cams Skunk2 dic
Block k24a
Rods a2 Tsx
Arp bolts
Pistons Type R 11.8:1 87.5mm
Type S oil pump
Bearings new
Timing oem honda new
Header skunk2 alpha
Exhaust 3 mandrel bent
Resonator ultra quiet vibrant with streetpower vibrant muffler
Nelvin Kbuilts engine and transmission builder
Elliot Tuning on a base tune because the TPS was faulty during dyno session. The best whp this vehicle had made was 265whp. The 1/4 miles runs are on a Elliot base tune revised, no final numbers available.
Hondata Kpro Bluetooth Ecu
Fuel
Aem Pump 340lph
Rdx oem 410cc injectors
Susp
Tein Basis Coilovers
Skunk2 rear control arm
Camber arms rear
No front sway bar
Extended wheel studs new bearings
Tires
Falken Azenis 225 55 16
Aros 16x6
Brakes
Wilwoods front brakes 2 piece rotors
Rear ventiladed disc
Power stop extreme pads
Transmission
Ep3 5 speed
Carbon synchros
Mfactory Lsd
5.06 Jdm final drive
Oem bearing kit
Oem shifter cables
Short throw shifter
500hp axles 36mm
Ig: @yad_performance
Hmmm, not sure I'd break into the 13's then. You've got more into your k24 than I do. Great video
With good tires its pretty doable this was a very soft launch with this power and street radials it would be in the 12s
Yeah buddy
❤❤❤
🤩💞
Very nice. Sounds good
Very good project; Why did you leave the factory 5-speed box?
Factory box works pretty good we just added an Mfactory lsd and new synchros with a 5.06fd
The best time at 2500 rmp
Yess sometimes less is more 🫡
Where did this car go?
Whp ?
Best whp 265 dynojet
Your tuning is like ,sleeping 😴
2 gear launch plz
16 sec car hmm
The time slip said 13.4@106 😉
Owner ig?
Yadperformance