Toyota 1kd & 2kd-ftv Timing Belt Set-up
ฝัง
- เผยแพร่เมื่อ 16 ต.ค. 2024
- Please support our channel:
G-Cash 09297681430
Thank you!
Timing Belt replacement guide applicable for Toyota 1kd-ftv and 2kd-ftv engine. Thank you for watching! Please subscribe for more.
#timingbelt
#2kd
#1kd
Thank you to hame bolna chahiye thanks aisi video banane ke liye
Yes sir, thanks too!🙏
If only all cambelts were so easy! Good video.
Thank you!
السَلآْم عَلْيُكّمٌ وٍرٍحَمُةّ الله وٍبُرٍكآتُهْ
Shokran modir!
ماشاءالله عليك ❤
Thank you!
Easy staff thank you for the video
Thanks too🙏
Good
Thank you!🙏
ขอบคุณครับ
Thanks
It seems so easy to do but when you tried it, it’s very difficult to do especially when you put back the belt. It’s very difficult to return it back so it would be better if you also show how did you return the belt w/o also difficulty in putting back the tensioner.
Thanks,
so the trick is vice press the tensioner pin it and booom.. done thank's! for sharing bro💪💪👍👍
I don’t have any problem with the tensioner because I can press it back. My problem is the timing belt because it’s short and no matter how hard I tried to fit it back, I just couldn’t but when I leave it to the mechanic, he was able to do it. So there must be something that you have to move so you could fit it back.
@@jazzmitz9657 when compressing the tensioner again do it slowly in small increments over a few minutes
Smart n simple
Thank you🙏
เยี่ยมยอดครับผม
Thanks
Thanks
Thanks too🙏
Hi mate, what kind of engine is 1kd and 2kd??
Diesel mate
Good job explain
Thanks
سلام من یه ماشین تویوتا هایلوکس مدل 2003دارم موتورش را تازگی ها تعمیر کردم ولی یک مشکلی که داره اینکه توی سرعت زیر 70کیلومتر موتور گاز نمیکشه میتونه این مشکل از سوپاپ ها باشه با تشکر
Im sorry i dont know arabic.
Hi, I have a 2003 Toyota Hilux car. I recently repaired its engine, but one of the problems is that the engine does not accelerate below 70 km / h. This could be a problem with the valves. Thanks
شكرا شكرا شكرا
Modir i dont understand arabic. Thanks.
@@DiYSpanner أنا أفهم اللغة العربية فقط
Tnx bro
Thanks too bro
Camshaft at hp pump lang ang nka connect sa timing belt sir di kasama crankshaft?
Oo sir
Ah ok,salamat sir more videos,sana next video toyota hilux
I have 2KD sir but i don't have an idea. please give me for valve clearance adjustment Intake and Exhaust also the final torque like; Crankshaft bolt, Connecting Rod bolt and Cylinder head bolt.. please please!... thanks
Thanks
Idol after mapalitan ang Timing Belt paano maalis yong lumabas na T-TIMING BELT sa Panel Board, lumabas nang umabot na ng 150,000kms?
To reset the timing belt indicator without Multi Information Screen (2013 on), proceed as follows:
Turn on the ignition.
Adjust the display so that it is showing the TRIP B reading. (See Diagrams)
Turn off the ignition.
Press and hold the trip meter button and turn on the ignition.
Continue to hold the trip meter button for 5 seconds or more ensuring that the timing belt warning light is flashing.
Release the trip meter button then within 5 seconds press it once.
You now have 5 seconds to select the interval to the next timing belt change. turn the trip meter button to advance through the interval options.
Note: the interval options will be a two digit number representing the kilometres multiplied by 10,000 eg: 15 = 150,000 Km’s
Or if not changing the interval hold the trip meter button for 5 seconds or more.
The display returns to the Odometer reading and the Timing Belt light will turn off
To reset the Timing Belt reminder message without the Multi Information Screen.
Switch the ignition ON and set the TRIP meter RESET knob (located on the lower right hand side of the cluster) to display the Odometer reading (not the trip meter reading) and then turn the ignition OFF.
Press and hold the TRIP meter RESET knob and turn the ignition ON.
Press and hold the TRIP meter RESET knob for a further 5 seconds, release it and then hold it in again within 5 seconds.
Enter into the SETTING MODE and change to T-BELT DISPLAY MODE.
Press and hold the TRIP meter RESET knob for a further 5 seconds.
The display now changes to TRIP B and the warning light turns off indicating reset procedure is complete.
Release the knob and turn ignition to OFF.
perfect
Thanks,
No need to change oil seal??
Oil seal still good for this engine.
Buenas noches si se parte la correa dobla válvulas o no
No estoy seguro de si este motor es interferencia o no interferencia. La válvula se dobla cuando la correa de distribución se rompe en un motor de interferencia. ¡Gracias por ver!
@@DiYSpanner quede igual pero gracias por el video
الله يبارك
Wow
Thanks
الفركنس كروا انترنتور
Какой интервал замены ремня на 2 KD?
Sorry i dont understand. Thanks for watching!
What is the belt replacement interval?
Every 100,000 km
Thank's!
👍👍👍
😅😅😊
Thanks
What would cause my tensioner not to tighten, is maybe the pin short and needs to be pulled up? Everything seems to be okay but still the belt won't tighten.
Maybe something wrong with the tensioner.
اريد أعرف كيفيه وزنية السير
Sorry, I have no idea about the weight.
Oky quando ter força e n acelerar
Nasty, tensor and poley no change, bad bad,
Thanks
se necesitan cambiar siempre ?
Look!!!
Thanks,