Multipul vfd communication setting with delta hmi on rs485 communication!

In this video we have told you how to connect one plc and multiple vfd with rs485 court of delta hmi, what is its process. What are the communication parameters?
#vfdcommunication
#hmivfdcommunication
#industrialautomation
delta hmi,delta vfd,delta hmi and delta vfd communication,delta hmi rs485 communication,delta hmi communication with multipul drives,delta plc and hmi communication,delta hmi se vfd ko communicate kaise kre,delta hmi rs485 communication parameters,delta vfd el series communication,delta vfd el series communicate with hmi

[@deepakpathakt5148]

Can you make video on vlt 2900 danfoss vfd i have no idea to make and address i have 5 vfd speed up down with 0 to 10 volt port plz

[@pablohernandezb6675]

Hi good tutorial, i just have a question what button did you use? I usually use the set constant button. Thanks so much

[@technicalmsautomation]

momentary type for inching, maintane type for holding

[@madhusudansharma7368]

Could you iff the beep sound its irritating creaton headphones

[@vithobakoparde8805]

Very helpful... Thanks for uploading... Sir how two or more vfd .should synchronize..( Vary using one master )

[@technicalmsautomation]

Use analog output voltage of master vfd to the slaves vfds,
Master vfd analog output goes to potentiometer terminal for synchronisation

[@vithobakoparde8805]

Thanks for the reply sir ...

[@dharmeshsolanki7882]

HMI ki program ke sath sir plc ki bhi program show kariye pls

[@technicalfundadharuhera7805]

Sir mitsubishi hmi delta plc possible h kya please btaye

[@technicalmsautomation]

yes

[@technicalfundadharuhera7805]

@@technicalmsautomation sir which mode of communication need to be set in GT designer gor delta plc
Please share if any video on this

[@technicalmsautomation]

@@technicalfundadharuhera7805 rs 232 communication

[@technicalfundadharuhera7805]

@@technicalmsautomation ok sir tried but not successful

[@technicalmsautomation]

@@technicalfundadharuhera7805 read hmi and plc default communication protocol,
If different than match (do same both) them and then try,it will be communicate..

[@Ch4fe-C0ffe]

how to make the physical part between the inverters and the HMI?

[@technicalmsautomation]

u have to communicate hmi and inverter through 2 wire, rs485 + and -

[@Ch4fe-C0ffe]

@@technicalmsautomation yes, I can connect 485 with an inverter, but my question is how to make the connection to other inverters

[@technicalmsautomation]

@@Ch4fe-C0ffe parallel connection all inverter and hmi with rs485

[@Ch4fe-C0ffe]

Não entendi como vc fez ? Vc ligou 485 em todos os inversores?

[@khatchigkondakjian8014]

Hello what is parameter?