+Andrea Starnini this is just tutorial for how to use gravity load and it's effect, when we design bridge so we have to apply proper boundary condition with wind load dead load , pay load etc....
OK...but shows wrong approach to the problem. I think that for any one that doesn't has a minimal skill on structural analysis could be missleading. This comment is valid for many tutorial posted
there is a mirror command in solidworks i dont wana criticize you but if you could use it here, you could save huge amount of your time and work on other things.
@@Designhubindia please make one more video on that to apply wind load and additional load (like a truck in center of 4 ton). Tell us how to define joints.
surprenant au premier abord cette vidéo mais très sympa !!! J'en veut d'autres
About Trim/Extend: When I put my front in, my back pops out. When I put my back in, my front pops out. It’s like trying to keep two dogs in a bathtub! ©Mrs Wolowitz
Excellent tutorial, thanks!
Good job!!!
what about welding joints and Bolted joints more stress would be developed at these points hence
Great video can you tell me how you define the span because I also wanted to create a truss bridge but I am little bit confused where to start
Thre are also hinge in addition to fixed support. Bridge structures are simply supported
+Andrea Starnini this is just tutorial for how to use gravity load and it's effect, when we design bridge so we have to apply proper boundary condition with wind load dead load , pay load etc....
OK...but shows wrong approach to the problem. I think that for any one that doesn't has a minimal skill on structural analysis could be missleading. This comment is valid for many tutorial posted
Right...But. design hub team trying to show only gravity load ...Not bridge design. Simulation study...
Though show in a proper and clear method as said. Your videos aee watched not only by students but also professionals.
@@Designhubindia please make one video on that...
How can I know the forces that are exchanged between two surfaces in one body?
Just want to ask, is the bridge model the real existing bridge?
That result how do you know its pass or failure?
I have this problem. Help us guys
@@aknyldrm9760 I think the red zone shows failure of the model because plastic deformation has been observed in the diagram
there is a mirror command in solidworks i dont wana criticize you but if you could use it here, you could save huge amount of your time and work on other things.
+shapuyzat this is only for students...In this video we are trying to link concept .. with sw
and so cool, I liked it. calculations of wooden roof trusses will?
The only load you apply is gravity ? What about the wind load or the load that this bridge is supposed to resist.
+Hani Rousta that simulation for due to own load ,only ..how much deflection due to that
. After that you can apply .
@@Designhubindia please make one more video on that to apply wind load and additional load (like a truck in center of 4 ton). Tell us how to define joints.
Can we use this analysis for non standard beams.
Yes...you can use...by this simulation only for - self load deflection.. this is not for structure analysis
dude , why didn't you just mirrored one side?
Максим Мельников Dude best way is making a 3d sketch and assigning sections in weldments.. Instead of such sleazy long procedure.
you didnt do any calculations for the deflection
how can i contact you ?
Do you provide training online or offline
Narendra Verma go for solidprofessor. Com. They can make you master of SolidWorks.
and so cool, I liked it. calculations of wooden roof trusses will?