We don't require using a Phillips bit with vise grips, it's just a little trick that we've found to make those steps easier. The reason we use short pan screws in the truss assembly is so that the roof panels can seat into the truss channels all the way. If there was a bolt going through to the other side, the roof panels wouldn't seat into place.
I'm planning to buy one of your sheds, I hope all the negative reviews were people who had no mechanical or assembly skills. In other words, I hope I don't regret it!
![F.HERO Ft. JSPKK x ลำไย ไหทองคำ x M-PEE - ไม่สนิทบิดหมด (Thai Riders Anthem) [Official MV]](http://i.ytimg.com/vi/kPJZ0UihBfk/mqdefault.jpg)
Thank you! I wouldn't have been able to build the shed without your video as the paper instructions were crap!.
"Make sure model number is listed in description below". Where is "description below"? Need video for 60079 (with skylights)... getting hung up!
What if you want the side door on the other side?
He explained when putting the floor panels on
Section 6.7 around 25:23
Do you open the boxes ,1,2,3, in sequence or do you have to open all 3 at once to access all the parts if you are only doing the floor?
All of the hardware is located in box 3 and the floor panels are located in box 2.
What's the point of the Machine Screws where you have to use a Phillips bit with vise grips? Why not just use actual bolts?
We don't require using a Phillips bit with vise grips, it's just a little trick that we've found to make those steps easier. The reason we use short pan screws in the truss assembly is so that the roof panels can seat into the truss channels all the way. If there was a bolt going through to the other side, the roof panels wouldn't seat into place.
I'm planning to buy one of your sheds, I hope all the negative reviews were people who had no mechanical or assembly skills. In other words, I hope I don't regret it!
are these instructions the same for the 60079 shed? many of these sheds are so similar.
What box is the manual in!!??
The manual can be found in box 3.
In 6.6 my floor panels only have 4 divots per seam not 6?! The 2 outmost divots don’t exist on my panels so I only have 20 total not 30
I ended up just skipping and anchoring 20 down, didn’t seem to cause much harm. Just about finished the build, video was very helpful thank you
@@JustShoveJayOhBe you saved me tysm