Hyundai Accent - FULL LED Upgrade
ฝัง
- เผยแพร่เมื่อ 6 ก.ย. 2024
- Upgrade all the lights of my Hyundai Accent to FULL LED.
Below are the links of the LED's that I have installed.
Auxito Seller Page
bit.ly/3a8b5wN
Headlight: Auxito H4 LED (1 Pair)
bit.ly/3NkFYMS
Parklight: Auxito T10 LED (3 Pairs)
bit.ly/3yJpv0s
Front and back Turn Signal: Auxito 1156 LED - 150 degree grove - Amber Color (2 Pairs)
bit.ly/3yJoVji
Brake Light: Auxito1157 LED - Red Color (1 Pair)
bit.ly/38ycAUx
#HyundaiAccent #LEDLights #DIYUpgrade #Auxito #LEDUpgrade
I have Hyundai Accent 2018 Gas, hindi ko na makabit ang dust cap after headlight installation compare to Halogen bulb.
I have h4 on my 2019 Accent but the 3 pins are at the end of a wire thet comes from the bulb instead of bieng part of the actual bulb itself
As for the tail light i put led and its burning the tail light now its dented in from the heat
I own the same car. I replaced the headlights with the Auxito 20,000 LM . low beam is good. high beam is really bad. very weak and the pattern is bad.
@SelfService. I don't know why my friend told me that if the car didn't come with LED lights he can't change it. He also told me that LED lights can fog up the headlights?
sir do you have a link on the dome light bulb also the reverse light bulb?
May i know the details of all the bulbs you install please
Check the links on the video description. Thanks
Very helpful.
10/10
Did you have to use a load resistor for your headlights to stop anti flickering
The fan is inside the headlight housing compared to other design where it's behind the heatsink and outside the rubber boot. Any noticeable moisture/condensation buildup especially when it's raining?
no moisture build-up as the dust cap at the back of the headlight is tightly sealed
@@Self.Service sir any warning light showed up after installing the said led lights?
Is your socket type similar with hyundai accent 2014 model?
How's the LED brand as of now? And I think it's much higher wattage than the stock bulb.
All LED's are still working good. I have not changed any bulbs yet. All LED are still bright
@@Self.Service Nice! If you have time, can you make another video just for the insights to show us the beam pattern or light alignment for Lo/Hi beam at night. Thanks!
@@Self.Service when you change all LED, you did not change any relay ?
@@jennmarquez4653 i never change the relay but i modified/hack the relay to eliminate the hyperflash.
see this video beloe for the steps
th-cam.com/video/F1OVRq0yzWU/w-d-xo.html
@@Self.Servicewhat if, only headlight bulb will change?also need to remove this resistor from the flasher module?
So lengthy video for changing of lights, some one might have assembled the whole engine in the same time 😂😂😂
Thank you for watching it 😜
How’s the performance after a few months pal? Also can you send me a pic of how it is during night? Thanks! Planning to buy the same LED headlight.
@selfservice, how is it during night?
How was it after 10 months? Especially the headlight? Is it ok to still use the factory dust cover? Any overheating?
Yes, still working up to now. no overheating, no moisture inside the headlight.
@@Self.Service already bought it. Ganda ng cut off ng LED
How did you manage to remove and replace the bulbs on the driver side? Napaka sikip sa 2019 Accent, hirap hugutin ng bulbs. Do you have any videos?
You have to remove the fuse box out of the way.
It takes a 10mm socket wrench.
Gumagana padin po ba ito till now? Planning to change LED headlight as well and saw this type of headlight where its just like the stock where you can close the CAP
working pa rin sir. hindi pa ako nakapagpalit since changing.
Hi, did you return the dust cap for the headlight after installing the h4 LED? It's the same dust cap shown at 5:58 of the video.
yes, I put back the same dust cap that I originally removed.
putting back the dust cap is on 16:00
pwede rin ba sa accent 2015 sir
Turn mo muna ang mga turn signals boss to check your if compatible
What year is this accent, pal?
2016 model
@@Self.Service Thanks, and you didn't have any issues fitting the headlights? I bought the same headlights, but I'm having trouble closing the dust cover, it seems to not fit, it sticks outside a bit.
@@capybaraponque611 have you inserted the locking pin tightly? For me it still has a small gap between the headlight pin connector and the dust cap.
@@Self.Service It worked, I hadn't put the light in the right position.
My hyperflash po ba ung signal light?
Meron sir and ito yung solution ko.
th-cam.com/video/F1OVRq0yzWU/w-d-xo.html